Question about HP Motorcycles

1 Answer

My 2007 150 hp four stroke has suddenly, after a three week haul out, quit flowing cooling water. Where do I start finding out why?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • HP Master
  • 79,865 Answers

Check the water intake first, is it clogged or otherwise restricted.

Posted on Dec 15, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a1998 Evinrude 70 hp 4 stroke engine that idles good but when it heats up the buzzer comes on .anyideas

Most common issue is cooling system. Buzzer is warning that motor is overheating. Run your motor out of the water connected to cooling water supply and check water flow.

Mar 30, 2018 | HP Boating

1 Answer

Water dispence slow

do you know if it is a whirlpool made model, 27ft french door, ice maker in ceiling, they had issues with a seal between ice compartment and ref side- leaks freezing air to water tank area, freezing tank. other wise if its not the filter -then water flow to unit. ck where it connects to ref, if good( should have steady stream with press. replace ref valve if bad look at your valve in wall or at sink.

Sep 14, 2012 | Kenmore Refrigerators

1 Answer

Hi im after the fuel mixture for a 125L husqvarna straight shaft brush cutter.thanks

From you manual:
Two-stroke oil
For great results and performance use HUSQVARNA two--stroke oil, which is specially formulated for our two-stroke engines. Mixture 1:50 (2%). To maximize the life of your trimmer, you may choose to use a high quality synthetic oil formulated for two-stroke engines. Mixture 1:50 (2%). Never use two--stroke oil intended for water-cooled outboard engines, sometimes referred to as outboard oil. Never use oil intended for four-stroke engines.
WARNING! Always ensure there is adequate ventilation when handling fuel.

1 gallon of premium fuel to 2.6 ounces 2-cycle oil. 2.6 ounce pre-measured containers are available at most chainsaw outlets.

You can find your manual here:
Enter the 3 digit model number (no XPs, Es, just the numbers)
Serial number decode – useful when downloading IPLs and Manuals
06 1500198
06 = year produced – 2006 (single digit before 2000)
15 = week produced - March
00198 = 198th unit Husky produced that week

Jan 24, 2010 | Husqvarna Forest & Garden 125l 18" Gas...

1 Answer

The fridge stops cooling because the freezer coils freeze up

If you are saying the coils in the back of the freezer section are becoming solid with a light snow and ice, and not allowing air flow, you have a defrost problem. If you unplug and let it all melt with the door open it will run ok for about three or four weeks depending on humidity and use.(you also have to manually defrost it to find the problem to fix.

To repair you need to replace one of three parts the bimetal thermostat, the defrost control, or the defrost heating element. Can not tell you without testing circuit with a meter. It the bimetal has a pushed up top it has got water in in and failed, otherwise you need a meter..... good luck

Jan 22, 2010 | Amana Refrigerators

1 Answer

Is this a two or four stroke

If it has a crankcase with oil in the base of the engine then it is a four stroke. Look for a plastic screw plug (normally has two small risers on it) that is where you would add oil for the four stroke engine, the level of the oil is normally just to the threads of the plug hole. Normally a 3.5 hp B&S engine is four stroke, but check just to be sure. I hope this helped, Good Luck Please rate me, Thanks

Dec 27, 2009 | Garden

1 Answer

2005 50 Hp Mecury 2 stroke out board motor issue

Does the boat get used regulary?(I,am sure that,s spelt wrong)Put a length of line trimmer cord up the hole whilst it is running.Sometimes a small piece of 'junk' slows the flow.If the water flowing out is not hot but still warm it is a good indication that there is no overheating.The flow should still be good.Even if the dealer says otherwise.Thats why all makers put the things there.Have a look where the hose goes with the engine cowl off.I have seen one with a kink in the hose.Hope this helps.

Jul 26, 2009 | Boating

1 Answer

We have a '95 Mercury 90 hp two-stroke that came with a Nitro 170

first thing is to find anthor shop you need to change the plugs drain the oil out of the resvoir and mix the gas and oil 50;1 that will keep you from fouling plugs and will probally fix your problem it sounds like it is getting to much oil try that and comment me back and we will get it fixed good luck try to enjoy your vaca

Jun 28, 2009 | Boating

1 Answer

Over flowing washer

If the water valve not getting 120 volts and its start filling that means its bad water valve if its getting 120 volts bad timer

Nov 03, 2008 | Kenmore Elite 45986 Front Load Washer

2 Answers

Water dispenser in my Maytag french door refer has suddenly stopped working. We use it every day and the filter seems to be fine. It almost sounds like it is frozen. Please Help!!!

We have a hd2560 (bot 10/04), french door with inside water dispenser and it had stopped working a year ago, but started working a few months later. I couldn't figure out what happened, but suspected the water line was frozen. I later found out that the water reservoir is located behind the fruit and vegetable bins, so look there to see if the water is frozen.

Two weeks ago, our frig/compressor stopped cooling after making humming/clicking sounds for weeks. Fortunately, Maytag has a 5 yr parts & labor warranty on the compressor, so we were covered. Evidently, there are quite a few faulty compressors out there.

I believe that the compressor had been over-cooling in the past and caused the water lines/tank to freeze. This would also cause frozen produce/fruit. I would immediately contact Maytag/Whirlpool if you suspect a faulty compressor as well.

Oct 24, 2008 | Maytag MFD2560HES Bottom Freezer French...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Experts


Level 3 Expert

1253 Answers

adam bikedoc

Level 3 Expert

661 Answers

ray gallant

Level 3 Expert

51521 Answers

Are you a HP Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides