Question about Suzuki VS 1400 Intruder Motorcycles

2 Answers

2002 suz intruder clutch wont dis engage - VS 1400 Intruder Suzuki Motorcycles

Posted by on

  • raybusuttil Jul 20, 2009

    forgot to say it was a hydralic clutch



2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

First , there is no cable to adjust or check. Suzuki uses a hydraulic cluth release on this model. There is a tiny hole in the resevoir on the handlebar,check the condition of the brake fluid in your resevoir.If it has not been changed in a long time,2 YEARS or more,Change it and clean the muck from the bottom .Make sure the holes are clear.Flush the system with clean brake fluid down to the slave cylinder located at the lower left side of engine. What is most likely happening is every time you pull the clutch lever the slave is moving out,with the hole in the master clogged the slave cannot return, this is leaving the clutch disengaged at all times.I would suggest checking this out before pulling clutches out ,or the engine out to check shift forks. Best of luck to ya, Gixrfixr.

Posted on Aug 05, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 850 Answers

Worn out friction plates & or warped steel ones mabe the springs or the pressure plate has come loose
check thae adjustment on the cable & the clutch at the housing to see if its pulling the actuator

Posted on Jul 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 Suzuki VS 1400 Intruder clutch adjustment

Hi, Bob your clutch may need adjusting for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing and printing please click on the blue links below. Good luck and have a wonderful day.
Intruder 1400 Clutch Adjustment
2002 Suzuki Intruder 1400 Clutch adjustment
Suzuki Intruder VS1400 Service Manual
OEM parts for Suzuki
Suzuki VS1400 Owner Manual

Jul 21, 2017 | 2000 Suzuki VS 1400 Intruder

1 Answer

Four wheel drive don't kick in

neither does my perfect, 04 GV , ever.... when.........
this is like the 1000 post for 4wd, an not one states
the road conditions. what are you driving ON >?
this car has Part time 4wd , NOT full time.
that means it's not to be driven on dry pavement in 4wd.
the operators guide tells you that.
PT 4wd is for ICE/SNOWpack and offroad, only.

what will happen if you do try to use 4wd is.
1: it will not engage.
2: or will engage but will hot dis-engage due to....
3: wind up. Suz, even has a UNWIND TSB !!!
TSB is a trouble service, bulletin.

dry means , ICE free

Feb 02, 2014 | 2002 Suzuki Grand Vitara

1 Answer

Does A/C clutch engages for heater as well?

a/c runs to condense moisture out of the incoming air as heater is running so windows wont fog up .a/c clutch will cycle fast when low and when switch is bad,

Aug 02, 2012 | 2002 Chevrolet Cavalier

1 Answer

Clutch not engaging

Does the clutch not engage( ie it slips & wont pull away) or does it not dis-engage (ie always in gear)
Was the clutch dismantled or disturbed when top-end was replaced
Is clutch hydraulic or not

Jan 31, 2012 | 2005 Suzuki RM 85

2 Answers

I have Suzuki VL 1500 Intruder bike. The clutch keeps dis-engaging and not operating right. Any ideas

Here is a schematic, parts list, and prices for your 2004 VL 1500. Friction disks wear out and have to be replaced at regular intervals. Clutch slipping is almost always remedied by replacement of the friction disks.

Dec 07, 2010 | 2004 Suzuki VL 1500 Intruder LC

1 Answer

How do I adjust the clutch cable on the 2002 suzuki intruder 800vs? I opened the resovoir to add break fluid now it engages instantly

the system is hydrolic there is know cable if it is engaging or slipping it is probably worn and needs replaced

Apr 13, 2010 | 2002 Suzuki VS 800 Intruder

1 Answer

I have a wet clutch an it wont engage the cable broke and the main shaft for the clutch on the inside is loose and moves aroundand i have a 2002 but on the web site it only has 2003 so i put that

I think you mean that the clutch has a broken cable and it is constantly engaged. The clutch dis-engages from the gear box when the clutch lever is pulled in. The push lever axle (I think this is what you are calling the main shaft) sits in a hole on the side cover. The gear on the axle engages the push rod and the push rod separates the clutch plates by pushing on the pressure plate to dis -engage the transmission. If the axle shaft is loose, check the lock bolt. Also check the cover plate. Is the casing cracked or broken at the mounting point?

If you are calling the push rod "the main shaft", then some movement is normal when the clutch is engaged as would happen with a broken cable. Please rate my answer. Thanks.

Feb 16, 2010 | 2003 Yamaha YZ 125

1 Answer

My bike is clutched

shift fork in trans is not engaging need to let someone open trans and sovle the issue those trans are not hard to fix but if you dont know how the shift fork needs to be to fuction seek pro help

Jun 08, 2009 | 2002 Suzuki VS 1400 Intruder

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

475 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

76132 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides