Question about 2003 Suzuki RM 125

1 Answer

How to change throttle cable on 2005 rm 125 - 2003 Suzuki RM 125

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Suzuki Master
  • 2,050 Answers

The carburator end...you will need to remove the seat and gas tank.The top of the carb will turn off counter clockwise, then you can pull the "slide" up out of the carburator. Note which is the front for re-assemble. There is a spring between the slide and cap, and look into the slide to see if your cable clips in, or may have a phillips screw and plate to remove to get the cable free. I use needle nose pliers to hold the spring back to remove and replace the cable.
The throttle end is easier. Remove the plastic cap and unthread the adjusting worm nut. The cable end "ball" will come out with the help of needle nose pliers also. Pull the cable slack up to rotate the "ball" out of the throttle tube.
Hope this helps!

Posted on Jul 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Suzuki rm 125 2005 model and ran it wide open to long and now acts like its flooded... already took Carb apart to clean figured float was stuck found a piece of dirt so I put it back together and...


Does the engine have good compression? The ring in a 125 does not last very long - the bike could be down on compression pressure. Re-ring it.

Is your air filter clean? I've seen them so filthy that they were actually brittle. Check your air filter.

How about your spark plug? They do burn out. Replace with a new one.

If it's loaded up, pull the plug, hold the throttle wide open and kick the snot out of it about 20 times, then put a fresh plug in it and try it again.

Good luck!

Oct 12, 2011 | 2005 Suzuki RM 125

1 Answer

How do you change a 1986 suzuki rm 85 engine to make it a 125 engine


I dont belive that it is possible, the barrel does not have enough metal to bore it out that far

May 23, 2011 | 2005 Suzuki RM 125

1 Answer

My son wanted to ride in the 12 degree weather-2003 Suzuki 2003 drz 125. He went to twist the throttle and heard cracking sounds and now the throttle does not return to the original position. Could he...


Yes it is possible to make it work,he has to dis assemble carb slide anyway,so while it is apart he can try it,should work though,doesnt hurt to give it a try.

Feb 10, 2011 | 2003 Suzuki DR-Z 125 L

1 Answer

How do i turn up the idel on my 2005 rm 125


there is an screw witha + head on it itis in the middle of the body where the slide goes up and down and about 1/2 up.

Jun 30, 2010 | 2005 Suzuki RM 125

1 Answer

Iv just changed the throttle cable on my lifan 125 but now it redlines when i start it up what have i done wrong help plz


throttle cable is either routed wrong or just hanging up or pinched somewhere when installed.

May 20, 2010 | 2003 Suzuki RM 125

1 Answer

No clutch control,bike stays engaged in gear with clutch depressed


assuming the cable is fine and you have pressure at the lever.sometimes the plates can stick together when it sits for a while. put it in top gear 6th, put the front wheel against a wall, hold the clutch in and put some weight on the kick start. or push start it and hold the clutch in and vary the throttle to try and free the clutch

Apr 05, 2010 | 2005 Suzuki RM 125

1 Answer

Over idling


Hey bro, throttle cable stuck, see if the carb mechanism is closed. Sometimes when you gun it it'll stick open. Get access to the carb and see if it is open or closed. If open then it is stuck, figure out if it is the cable or the carb mechanism that is caught and lube it. If the carb is closed you might have an air leak causing it to run lean but if this were the case it's rev high, but not red-line high. Cheers bro.

Apr 03, 2010 | 2003 Suzuki RM 125

2 Answers

When started up revs straight up as hard as it will go and wont settle down,throttle cable is fine can here the plunger in the carb movin,its a 2005 rm125 thanks


see how far your idle screw is turned in if not your slide barrel in your carb is sticking back srew counter clockwise an see what happens

Nov 23, 2009 | 2005 Suzuki RM 125

Not finding what you are looking for?
2003 Suzuki RM 125 Logo

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...