Question about 2003 Suzuki RM 125

3 Answers

How do i set my suzuki rm 125 carb to the right setting and does any 1 know what the setting should be please thanks graham

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

Turn the air screw and throttle screw all the way inward. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. The carb is now set back to factory specs assuming no one has changed out the main jet or played with the float level..

Please rate this solution. Thanks!

Posted on Aug 03, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hi i have a 2001 suzuki RM125.It wont kick start hot or cold and the power band will not kick in,It will start write up if push started.I think its so cool your helping people like this.THANKS Greg..N.O. L.A.....

Posted on Mar 18, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 40 Answers

Check for spark when kicking it over you might not have low rpm spark could be the rectifier I believe its called it produces the energy that gives the bike spark or stator if its four stroke

Posted on Dec 23, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does an 1998 Suzuki RM 125 Engine fit into a 2000 Suzuki RM 125 frame ?


Hi, Anonymous after careful deliberation 4 out 5 Suzuki Gods give this one a thumbs down, but just to be on the safe side you should give your local dealer's parts/service department a call to confirm. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
will my 250 motor fit in newer 125 frame Suzuki 2 Stroke
RM125 250 frame
Dirt Rider Magazine
http://www.vitalmx.com/forums/Moto-Related,20/Suzuki-RM-250-Conversions,1247347

Jul 24, 2016 | Suzuki Motorcycles

1 Answer

My 2003 Suzuki rm 125 kick starts with brand new spark plug then eventually bogs down and dies, does the same when push started, does it need new piston and rings?


HI,,sounds like your plug is fouling,,what pre-mix ratio are you running? and has the carb been played with? run 32-1 premix and remove and clean the carb.

piston and rings are not to blame for this behaviour.

Mar 23, 2011 | 2003 Suzuki RM 125

1 Answer

Needle adjustments for 1999 Suzuki RM80 Need carb needle setting for idle screw and air fuel mix screw.


Lightly seat the screws then open up each of them one and one half turns. This is the factory setting.

Aug 11, 2010 | 2003 Suzuki RM 125

1 Answer

1983 rm 125 float level


just make it look lever and straight, nothing should be bent in there, take a different or old junk carb apart and you'll see what i mean, they're all the same.

Nov 25, 2009 | 2003 Suzuki RM 125

1 Answer

What is the spark plug gap for a 2001 RM125and how do i set my carb for 3000 feet it is set for 700 feet right now


Set the gap at .30. No carb adjustment is needed. The factory range is sea level to 5000 feet.

Nov 20, 2009 | 2003 Suzuki RM 125

2 Answers

I recently bought a suzuki rm 125 and it wont run with out me giving it revs y is this . i cant leave it to tick over because wen i let off the throttle the bike dies????


the idle buddy is too low,on the carb is a screw the ide screw turn it in 1/4 of a turn with the bike running untill it idles the way you want it too and it will idle the pic below ill help ya buddy 34c510c.jpg

Sep 22, 2009 | 2003 Suzuki RM 125

Not finding what you are looking for?
2003 Suzuki RM 125 Logo

4,986 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...