Same voltage as the batteries in series connection ( 12 volt batteries connected positive to negative is series and would be 24 volts
batteries connected positive to positive will be 12 volts
Well turns out those are 12V 5W simple ligjt bulbs...i want to change them to an led light bulb that is 12V but 10W...will there be a problem?
there will be a big problem
it may be 12 volts but I doubt very much if it will be 10 watts as LED lights ( light emitting diodes) are very low power consumers and when used as replacements have additional electronics to make them work
find a good electronics shop and discuss what and how to do it
×
SOURCE: Wiring front fog lights to a 2002 freelander ES.
Do not fit these lights yourself,you must take the vehicle to the dealer to have it done .Firstly as vehicle wasnt factory fitted you need the original homoglonation certificate from the manufacturer for the model with the foglights fitted,then you need a installation project drawn up by certifide auto engineer with the relevent technical qualifications (i have them) then they can only be fitted by a garage with an added value tax certificate,then vehicle must be presented to the local vehicle inspection depot to be mechanically inspected all over weither its due or not,the relevant paperwork plus the fee presented ,then a new vehicle registratrion document issued showing the changes.Failure to to this will cause the vehicle to fail its inspection when next presented as paperwork isnt correct ,the lights are ilrevelent as to weither they work or not,but if fitted from new they must work.Also if stopped by the guardis civil and paperwork checked,and they notice then you risk having the vehice impounded their and then on the spot ,big fine and the cost of the removal truck.
SOURCE: 1994 Camry - Brake Lights Work, Tail Lights Wont
Well Jennifer, it sounds like you've done all the things that I'd have done. Try for a bad ground next. Do the lights in the dash cluster work? They're wired together with the tail-lights (so that you know if the rears go out). There should be a ground wire somewhere connecting the body to the engine or chassis.Look around the rear of the engine bay. Good Luck.
SOURCE: 2004 Landrover Freelander stop/reverse light fuse keeps blowing
I had a persistent problem of hill light warning and TCS warning lights coming on for no apparent reason. There is a wire connection between the stop light switch and the control unit to let the system know when brakes are being applied. Changing the stop light switch cured it. The replaced switch was certainly sticking and the new one was of a different design. Replaced it myself as switch comes with a wiring loom. Need to get on your back under the steering wheel! Not very expensive. My car 2001 TD4
Les
SOURCE: low beam light bulb issue rsx type s acura 05-06
The three prong base is just the bulb holder.
Here is an excellent tutorial on how to change the build:
http://forums.clubrsx.com/showthread.php?t=303640&highlight=change+bulb
Testimonial: "Thanks,i went to the Acura dealer and bought the missing sockets!"
SOURCE: How to replace fog light bulb on an '03 Jeep
There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose.
131 views
Usually answered in minutes!
×