How do you set the clutch on 1997 Yamaha wolverine ?

Question edited for clarity, full make model (what is is).
Question moved from 'Office Equipment' to Yamaha sub category.

All mentioned here. I would stick with 33.1 degrees.

https://www.wolverineforums.com/threads/tilt-to-roll-over-degree.29718/

https://www.google.com/search?q=2021+4max+1000%2C+tip+over+angle

..

It is a known issue. Lots of text articles and videos!

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk03EWl0mTEkcHOevvDzDb760WEt-jg%3A1612479558522&ei=RnwcYJC4H82GsQWkmZ7IAQ&q=350+Wolverine+Yamaha+no+spark

..

lever might need adjusting. check all your fluids too, not sure if the wolverine has a separate gear case.

clean the carb and check the float height

try yamaha forums thats where i go for wiring diagrams. ask for shop repair manual. let me know if you cant get 1 there.

I would just get another starter unless you can rebuild it.

Does the valve when setting have to be up or downtiming

Check the battery and make shure it is fully charged. Check the coils to see if they have went bad. You can have them tested at any repair shop. Last the CDI could have went bad.

it sounds to me like you have a faulty terminal, check voltage reading to the relay from battery pos terminal, now push and hold button and recheck on same terminal, if it stays at around 12volts check terminal on other side of relay it this is lower significantly than first side replace again with new relay. of both terminals voltage drops you have faulty battery.