I have a TS01 Newfittness treadmill and the dashboard is not working properley the slow button s not working and stop and start not working anyone has any ideas

Simply just slow down your treadmill until it comes to a complete stop. And then hit the stop button now many different treadmills have different ways of resetting. Most modern treadmills have a reset button on the back of the console or someplace on the front. If the treadmill's screen isn't working, you can use this to reset it. If the on/off button does not work, press and hold the treadmill's reset button for 10 seconds before turning it back on. It will begin to function.

is the emergency stop strap attached to your wrist or the machine

Treadmill console needs to be replace

This may well be either the
Console
LCB
Post wire

replace the old batteries by new ones, clean the contacts batteries very well.
2) tight the ribbon cable inside, for keypads and clean it.
3) Adjust the REED switch, test for open or faulty clean it, and tight the connector very well, see the diagram attached.
See the block diagram
after you fix it , if the problem remain with the same problem , the display board is faulty.
God bless you

RUN THE SOFTWARE CALIBRATION FOR EASY DIAGNOSTIC, TROUBLESHOOTING, AND FIX IT.
GOD BLESS YOU

RUN the software calibration INMEDIATELY, for diagnose, troubleshooting and fix it.

sincerely. God bless you

What do you do when EO shows up on your treadmill. We have tried to put the safety switch back and also replug the treadmill into AC power directly as suggested in the manual but it hasnt solved the problem.

Hi,
try this link
http://download.wareseeker.com/ts01/

thank you

i just called the manufacturer on this and found out i have a faulty control panel, but these are the steps they told me to go through to reset. If it works, then you are good, if not, you may also have a control panel issue.
1. plug in and turn on treadmill, keep red key out
2. press and hold the stop button and speed up button at the same time and hold them while you insert the red key
3. after red key is inserted, let go of both buttons
**CAUTION - be sure to stand on side bars of treadmill, clear of the belt for this next part bc it will go VERY FAST***
4. press stop button once
5. press speed up button until it reads 85 (see what i mean?!)
6. press stop button once
7. press incline down or up one time and it should get back into normal mode. mine just started a series of flashing lights and "8"s in all the "windows" so my panel needs to be replaced. here is the number i called - 1-877-993-7999. Good Luck!