How can I get my Gilera DNA 50 2002 lights to work..? Full beam and rear breaks are all I have, no speedo etc..? Please help this novice ??

Worth a try.

run a bead of clear silicone between bezel and glass. You might want to mask off the clear glass and cut a small gap about 1/8" into the glass with a razor blade or X-acto knife (they will not scratch glass - if it is glass). Then use the clear silicone - let it start to harden for an hour (pull tape off before it sets completely).

INCORRECT PRODUCT CATEGORY

I'm sorry but I believe you have this posted in the wrong product category? Please re-post the question in the proper category if this is the case, otherwise you have my apologies. This is the car and truck problem category

INCORRECT PRODUCT CATEGORY

I'm sorry but I believe you have this posted in the wrong product category? Please re-post the question in the proper category if this is the case, otherwise you have my apologies. This is the car and truck problem category

if you're looking at the bike from the rear, the module is on the r/h side of the cyl head under the faring.

first drain the fuel,, your probably going to have to get the carbs cleaned too,, gas turns to varnish like substance after about a year ,, yes a new battery should be purchased,, look for any cracked or weak lines both vacuum and fuel, replace the fuel filter, once you do get it running,, check far any gaskets that may be leaking, other than that you should have it as far as starters

Have you tried bob wright motorcycles they are based in westernsuper-mare but they are a gilera stockist new and used parts and offer mail order check them out on the web.

Sometimeds it's like this: left is normal beam and right is high beam or similar...
so in that case it might look like it's failing,
otherwise check your fuses, check the wiring, check the lightbulb....

I hope this is helpful, and greetings,

Olivier.

no, if it starts on the kicker petrol is not an issue, could be battery though