Question about 2005 kawasaki ZX-10R

1 Answer

ZX10r will crank over but will not fire up.

Changed spark plugs but still will not start.  Does the bike have relays or anything electrical that might have gone out?  I believe this is fuel related.  LMK

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 13 Answers

Did ypu change the plugs yourself

Posted on Jul 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Got spark new plug fuel carb changed won't fire or start


Is the plug wet?, maybe it's either flooded or it's not getting fuel.
Pull plug if wet dry it, make sure fuel off and crank bike with out plug in to clear the cylinder. Replace plug, try to start. if it doesn't start then you have to determine if it's flooding or if it isn't. Hows the spark look? Orange or white/blue? How fast is it cranking? Is the battery fully charged?

May 27, 2015 | Motorcycles

1 Answer

Harley Davidson - FXSTI Softail standard cranks but will not start


If the bike has carbs, try cleaning them because the only other problem is that the bike is not getting fuel.

Apr 17, 2014 | Harley Davidson Motorcycles

1 Answer

Yfz 450 only runs when pull started. Wasn't and haven't had any such issues starting it any time before.


Hi, Sal and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose, check for spark leakage in the dark.
6. Faulty ignition coil, pick up coil, trigger coil or CDI box testing needs to be checked with an ohmmeter at 70 degrees Fahrenheit
7. Faulty safety switches clutch, kickstand, neutral, off/on etc.
8. Faulty ignition switch.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Wierd one spark then nothing KLR650
Single spark then nothing
YAMAHA YZ450F Owner Service Manual
OEM parts for Yamaha
http://www.yamaha-motor.com/assets/service/manuals/2004/lit-11626-17-11_784.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Jan 18, 2014 | 2004 Yamaha YZ 450 F

1 Answer

77 gs 750 wont start


on the starter relay cross the 2 bolts to see if this starts the bike with ignition on. presuming it has electric start

Mar 10, 2013 | Motorcycles

1 Answer

2005 equinox died n won't turn over again.


As with any no-start condition, you first need to know if it is no spark or no fuel.
You could try spraying carb cleaner or starting fluid into the air cleaner hose to check for no fuel. Or pull 2 or 3 plugs and check for spark.
Also take a look at the ECM for trouble codes.
It could be anything from a plugged fuel line to the gas tank to a bad relay to a dead ECM.

Jun 26, 2012 | 2005 Chevrolet Equinox

1 Answer

I have a Kawasaki zx10r i replaced battery and after riding bike for few minutes u loose all power to bike lights and tach lights on console than have to jump bike to get it to start than it will do again


I bought a 04 zx10r. good battery but no electrical power any where but the starter relay. all of the suspected componets were chect on a running bike and perfermed normal. the issue was in the wire harness. I found a short in the #1 terminal connector on the left rail of the seat frame. It is hard to find as it is wraped in black tape. I found that the wire terminal had corroded and broken into. This wire leads back to the positive side of the starter relay and from that point it powers almost everything on the bike. I hope this helps. Good luck. Gixxerboy.

Jun 23, 2012 | 2007 kawasaki Ninja ZX10R

1 Answer

Will not start


If your kickstand was down when you tried to put it in gear it will kill the engine. And not start until the clutch is pulled in.

Jun 23, 2012 | 2005 Suzuki Boulevard C50

2 Answers

Starting problems st50-3


Does the motor try to turn over? Does it make any sounds? You need to check the battery use a volt meter and check the voltage it should be at 12-13 a little less is ok. Now while the meter is still atached turn the bike on and try to start it. Watch the voltage drop it should not go below 9 volts. If it does then your battery may not be able to produce enough volts to run. If your battery is good. The easiest way to start looking for the problem is to start at your spark plug. When you test spark plugs you have to ground them . So lay the part of the plug that screws into your cyclinder head on the motor. You should be able to see it spark if its good. DO NOT hold the sparkpug while turning it on. It carries very high voltage and it will hurt enough that you will never forget it. I would assume you have already done this but if you havnt get a new spark plug and try that. If there is no spark then you should check your coil. If you follow the cord that plugs on to your spark plug to a box looking thing and take your volt meter and and put the gound to the ground on the battery and put the power on the wire going into the box on the other side of it form where the spark plug wire is and see if you have any voltage when you turn the bike on and try to start it. If you do then your problem is either the coil or the wire that goes to your plug. I believe they come as a set when you relace that. Keep going back thru the wires in the same manner checking to wires and components. I am having a hard time finding a wiring schimatic for your bike so im not entirely sure where the wires go from there. Hope this has helped you please give a review. Good luck
A.J. Weaver

Apr 20, 2012 | Motorcycles

2 Answers

96 bandit, wont start,will turn over but not fire up, have changed plugs, drained carbies, checked for spark, still not firing up, any ideas?


check fuel filter and shut off in float chamber , if you have spark and gas , still not firing check timing .

Mar 18, 2012 | 1996 Suzuki GSF 600 S Bandit

Not finding what you are looking for?
2005 kawasaki ZX-10R Logo

Related Topics:

525 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4988 Answers

yadayada
yadayada

Level 3 Expert

80531 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...