Question about Yamaha SR 125 Motorcycles

1 Answer

Yamaha SR125 Carb Problem

I have a YamahaSR125 It will start with choke out full but as soon as you push choke back in it stops it will run ok with choke out but races alot I have been told it might be the jets or O rings I have had carb cleaned out and its been put back ok Could any 1 Help am at my wits end. I have tried to find a carb over haul kit or a new carb on the net but cant find anything

regards
cheesey

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 50 Answers

Sounds more like when the reinstalled your carb after cleaning, they did not ensure a proper seal from the carb to intake manifold. This is common! It could be no more than an intake leak. Start your motor and Spray a little WD40 just behind the carb on the intake seals. Be carefull not to spray into the throat of the carb as this will cause a false reading. A variance in the idle of the motor when you do this indicates an intake leak.

Posted on Jul 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a CS4518 Earthquake chainsaw that will crank fine when you pump a little gas to the carb, but stops as soon as it burns the gas. I have replaced all fuel lines, primer bulb , cleaned the carb and...


Hi, OK firstly when you pump the primer bulb the primer bulb pulls fuel from the reservoir and pushes it to the carb then after around six to ten pumps the carb chamber is full and the fuel then goes back to the feservoir. Normally if you have a leak on the fuel line you get air in the priming bulb. Next thing is having primed Put the choke on full and pull the engine over a few times untill you hear it fire. Then depress the throttle and put the choke lever back to normal run position and pull the starter a couple of times untill it starts. Thats a pretty fool proff method on all two stroke machines and I have a few. Hope that is of some help.
Steve

Aug 28, 2013 | Garden

1 Answer

Yamaha sr125 shudders then stalls when accelerating


Hi, Tybeale and the usual suspects are:
1. Idle circuit and transfer ports clogged.
2. Air fuel mixture adjustment too lean.
3. Pilot jet clogged.
4. Faulty accelerator pump.
5. Float level too low.
6. Float bowl contaminated old fuel, water, dirt, rust, etc.
7. Float bowl vent or overflow tube clogged.
8. Fuel flow to carburetor restricted.
9. Intake manifold leak.
10. The gas cap is not venting properly or fuel tank venting system blocked.
11. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
12. Needle and seat stuck closed in the float bowl.
13. Multi carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Yamaha SR125 cutting out HELP
2002 50cc Yamaha Vino Stalling on Acceleration 49ccScoot com Scooter Forums
Yamaha SR125 1997 Service Manual
OEM parts for Yamaha
YAMAHA SR125 Owner Manual

Feb 12, 2013 | Yamaha Motorcycles

1 Answer

Yamaha dt125 runs on choke


The cause of this in most gas engines is a plugged jet in the carb. It must be taken apart and thoroghly cleaned. The jet must be unplugged with a stiff wire or paper clip if it will fit. Carb cleaner alone will not do the trick.

Sep 30, 2012 | 2004 Yamaha DT 125 R

1 Answer

Yamaha ef1000 will start then push choke in and generator stops


clean tank fuel lines air filter and completely clean all carb parts and jets just did mine runs mint now did the same thing i also put in a new spark plug changed the oil a good once over goes a long way just take your time use a good carb cleaner like crc or gumout and check the jets they have small holes on the sides that can clog up hope this helps

May 07, 2012 | Yamaha 1,000 Watt Portable Generator...

1 Answer

Yamaha 2005 v star classic will only start with choke on put in new battery still same problem push choke in stops running


sounds as though its a carb jetting problem. srip and check the carb or get it done if you are not confident enough to undertake the project.

Sep 07, 2011 | 2003 Yamaha V Star Classic

1 Answer

Yamaha sr 125: choke is pull and twist to lock on, the twist part does not work so choke will not stay on unless it is held out by hand, any ideas!


Hi, Badgerbrooke replace it for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
SR125 CHOKE
Alternative Carburettor
Yamaha SR125 1997 Service Manual
OEM parts for Yamaha
YAMAHA SR125 Owner Manual

Jul 04, 2011 | 2001 Yamaha SR 125

1 Answer

I have a coleman powermate premium plus 6250 generator,put in new plug ,new filter ,changed oil,cleaned the carb,put in new gas. runs ok at half choke but when go full choke it starts backfiring and runs...


if you are running the engine at full CHOKE, then it is flooding the engine, but if you meant off full choke, then the carb is still stopped up. Try soaking in carb cleaner overnight after removing jet & all rubber goods. HOPE THIS HELPS.

Dec 17, 2010 | Coleman Powermate Premium Plus 6250W...

1 Answer

Yamaha TW 200 starts but won't run.


If the bike has sat for a long period of time without being run - the gas that is sitting in the carb(s) will shellac.. Then the carb(s) would need to be cleaned and "rebuilt"..

Sep 14, 2009 | 2001 Yamaha TW 200

2 Answers

1979 yamaha xs400 will only run on full choke as soon as you shut off the choke motor dies just cleaned carbs twice


it is either a float problem with the carbs or a jetting issue. i would check to make sure you have flow thru your carbs .

Jul 08, 2009 | 1979 Yamaha XS 400

2 Answers

Strange thigs about YAMAHA TW 125


Hi
I have been working on my carb today,the pipe from the bottom of the carb should just run down by the bottom of the swinging arm,there should be another pipe from the pipe on the left side of the carb just above the fuel intake which also runs down to the swinging arm and connect to nothing.
Cheers

May 30, 2009 | 2001 Yamaha TW 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

409 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...