Trouble shooting starting seyteam - Motorcycles

Hey Ron,
AN internal combustion engine requires three (3) things to run...assuming the internals are good.
1. Adequate compression >120PSI
2. A properly timed spark
3. A proper fuel/air ratio

Start with one, and eliminate one at a time(make sure it works) - ..(this is the way a professional would trouble shoot an engine).

Sound like its not engaging in that case...replace starter

if battery not charging most at fault will be alt
ernator

when you start it do u use the choke right , when starting close choke when it starts open choke you prob fouled the plug clean it put back it walah

has defective board there is limited info on trouble shooting board just replace it it comes with the power supply also all in one

This WEB site has a trouble shooting guide.
http://www.ehow.com/topic_1844_laptop-troubleshooting-guide.html

It's because you have too much going on during start up. Go to Control Panel and then press Troubling shooting, you want to trouble shoot PERFORMANCE ISSUES. After this starts it will ask to show the start up programs, you need to decide what is important and what you need to start up...the other things disable them.

its the actuator solenoid

The only quick trouble shooting I can give you. Try unplugging the washer for fifteen minutes. If that doesn't do it then it is timer or motor.

There is not a easy 5 simple step trouble shooting system for computers.
BUT there is a trouble shooting flow chart for computers.
Go to this WEB site for this trouble shooting flow chart.
http://www.fonerbooks.com/pcrepair.htm