Question about 2002 Honda CR 125 R

1 Answer

Wont start sounds like it doesn't even try to fire

1986 Honda CR80 replaced carb, manifold, air cleaner and spark plug. Ran fine for about 10 minutes then nothing. Tried replaceing spark plug didn't change any thing, new fuel different oil nothing. Has spark on plug when pulled dont know how hot. Haven't ran a compresion test yet but does have compresion. any advice will help places to start looking or testing. Thank you

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 33 Answers

Check the rectifier.

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ran straight out the box


Sounds like you ran it with the choke on - best bet is to take the carburetor apart and make sure the float isn\'t suck and clean it out. Take out the spark plug and spray it with carb cleaner and dry it - wipe out the spark plug area. Reinstall the plug and carb. Give it a pull a few times let it run then adjust the throttle to the lowest setting and then back to the desired operating speed. Listen to the engine you should be able to hear the choke cut off when you adjust the throttle.

Jan 12, 2013 | Husqvarna Sewing Machines

1 Answer

1984 Honda CR80 will not start


Hi, Antonymace and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Cr80 Will not start
1985 cr80 not starting
Honda CR80R CR85R service manual repair 1995 2007 CR80 CR85 Download... $15
https://www.partsfish.com/page/oem-parts-for-honda
http://mybikemanuals.com/honda/honda-crf-owners-manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Sep 15, 2012 | Honda Motorcycles

1 Answer

My Toro Model 20070 that until now has always started on the first pull, won't start at all now. It started fine last week. It's getting spark (a little more yellow than blue). I replaced the plug,...


Hold the butterfly valve (behind air filter) open with a screwdriver, while somebody else tries to start it. Toro has had problems with atuomatic chokes. If it fires right up, thats the problem! If so, just wire it open, or contact Toro for a repair kit. Try using starting fluid, not carb cleaner, and spray directly into the head through the spark plug port. If you didn't do it already, blow out all the ports in the carb with compressed air, or carb cleaner. Also, be sure the safety lever is engaging correctly (top bar on handle) at the engine. Lawn mowers are pretty simple, so the problem is most likely simple too.

Sep 24, 2011 | Toro Personal Pace CARB Walk Power Mower

2 Answers

1986 Honda CR80 quit running


C A R B U R E T O R .. have a qualified professional take a look at it....

your bike only needs THREE things to run,,(assuming the insides are good),,
1. A timed spark
2. Adequate compression
3. Proper fuel/air ratio

Start with one... eliminate one at a time until you find out which one is NOT happening!! (This is how a professional would trouble shoot your bike)!

Sep 24, 2017 | Honda Motorcycles

1 Answer

I just purchased an 86 suzuki gs550l.Will not stay idleing after the choke is open.Even after it is warmed up. I thoroughly cleaned the carbs,checked for air leaks around intakes,cleaned and tested the...


I did a Suzuki 550 carburetor over haul 10 years ago and had 3 of the 4 intake manifolds crack or separate. I would start by closely inspecting the manifolds. Have you tried draining a carburetor bowl to see if it is full of gas? If the vacuum line to the fuel petcock is not hooked up correctly you could just have fuel starvation. You can hold a spark plug to a cylinder head and turn the motor over to see if you have spark. Correct amount of fuel, correct amount of air, and spark is what you need.
I just gave that answer to some one else. The fact is I had to remove and clean my carbs 4 times . Each time I did it, I got one more carb to idle. The last carb to work for me was the vacuum nipple carb. By the time I was done I had to replace all four manifolds they had all separated or cracked. To get my carburetors working I turned them upside down and shot through them with carburetor cleaner in the morning before work and in the evening after work. The reason it wont idle is the carburetor passageways are still plugged in the slow circuit. Carburetor cleaner , air pressure, and in my case time to get the blockage out of the bodies. When I was done it ran great.

Sep 21, 2010 | 1980 Suzuki Gs 550 L

1 Answer

I have a 1991 honda cr 250 I cant get to start at fist gas ran right thru carb and out bottom i took carb apart and got the floats to stop sticking cleaned it out with carb cleaner put back together but...


try a new spark plug. if u fowl out a plug some time they will not fire under compression.2 strokes need. fuel,fire and air, very simple engines.it is possible crank seal are bad .that doesn't allow the engine to create vacuum in the crank case.thus fuel and air will not make it to combustion chamber.

Jul 11, 2010 | 2002 Honda CR 250 R

2 Answers

I have a 1986 Honda Cr80 dirt bike and it starts first kick with no choke, and it will idle and then as soon as i put it into 1st gear it will bogg out and die or sputter and it usually wont open all the...


If no choke is needed then your mixture is to rich or not enough air is getting in,first check your air filter is clean and replace if needed,the mixture screw usually is about 1-1 1/2 turns out from fully in.if this fails then your carb will need striping and cleaning.common on off road bikes.

Mar 04, 2010 | Honda CRF 100 F Motorcycles

1 Answer

Put new carb on 86 cr 80 ran fine 4 10 minutes then quit changed spark plug and gas still nothing. has spark dont know how hot also changed manifold appeared to be dry rotting still nothing. even attemped...


for any motorcycle to run you need three things. spark, fuel and compression. i see you've tried to get fuel and spark. if you have spark thats one down. dont pour fuel into cylinder. instead spray tiny bit of brakeclean or carb clean into spark plug hole. i have a feeling if you drained your gas after the carb clean the carb most likely sucked bad gas back up and might need cleaned again. ive seen it happen alot on ols bikes.

Jul 11, 2009 | 1993 Honda CBR 600 F(2)P

2 Answers

Won't start, small engine guy said carburator needed to be flushe


Hi lackeyapda:
Fire Air Fuel

Remove the spark plug, plug it back into its wire. Hold it close to the metal frame WITH INSULATED PLIERS. Pull the cord and see if you get a spark. If no it is the coil, plug wire or a safety switch. If yes
put it back together. Take the air filter off. Spray some "easy start" or "carb cleaner " into the carburetor. Try starting. If it starts for a moment then dies, you do need to clean your carb.

Jun 30, 2009 | Honda Karcher G2400HH-R Pressure Washer

2 Answers

Wont start after it died one night


The cap should be marked for number 1. The distributor turns clockwise. The firing order is 1-3-4-2.

Mar 22, 2009 | 1986 Honda Civic

Not finding what you are looking for?
2002 Honda CR 125 R Logo

531 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5065 Answers

Marvin
Marvin

Level 3 Expert

81424 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...