Question about 2000 Harley Davidson FLHR-FLHRI Road king

1 Answer

1988 FLHS starts only with c hock pulled and only runs for 10 sec then stops

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 47 Answers

Your petcock is dirty and needs to be removed and cleaned also you need to pull the float bowel off and cleanit while your at it spray out the carb from the bottom up and put in a new fuel line to carb and from tank to tank

Posted on Aug 22, 2009

  • paule64 Aug 22, 2009

    your petcock is dirty and needs to be removed and cleaned also you need to pull the float bowel off and cleanit while your at it spray out the carb from the bottom up and put in a new fuel line to carb and from tank to tank

  • paule64 Aug 22, 2009

    your petcock is dirty and needs to be removed and cleaned also you need to pull the float bowel off and cleanit while your at it spray out the carb from the bottom up and put in a new fuel line to carb and from tank to tank

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What years gas tanks fit 1987 harley davidson flhs


Hi, Ira I believe 1983-1988 for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary, transport your bike to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.Harley Davidson FLHTC 1340 EIectra Glide Classic 1983
Harley Davidson FLHS 1340 Electra Glide Sport 1988
Harley Davidson Manuals Mark Workshop
http://www.stcharlesharleydavidson.com/OEMpartfinder.htm
Owner Manuals Harley Davidson USA

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Dec 30, 2015 | Harley Davidson Motorcycles

1 Answer

Ford F150 5.4, 2002 A|C clutch run for about 10 sec then stops


Try a jump wire across the low pressure switch on the receiver dryer,if
the clutch engages and stays on check for cold air.
if no cold air disconnect jump wire and regas.

Mar 02, 2013 | 2002 Ford F150 Regular Cab

2 Answers

1988 chevy S10 turns over but won't start getting spark put in new fuel pump,cpu and injector. If I pour A little gas in throttle body hole it will fire for a few sec. fueses all test good.


Hello, just had this problem myself. Check your EGR valve by pulling the vacume line off and pushing up under the valve put your finger over the vacume line hole and release the valve, if it returns to normal position then its bad if not its good. If its bad it needs replaced. Mine did the exact same thing and thats what it was. Hope this helps

Jan 20, 2013 | 1988 Chevrolet S-10

1 Answer

Starts then dies doesnt matter how much gas u give it runs 10 or 15 secs then dies not missing all the time


Hi, based on the details you gave concerning your car, i suggest you check your fuel pump and fuel filter. They are the most likely cause of such problems...

Jan 04, 2011 | 1988 Isuzu Pickup 2WD

1 Answer

Blows black carbon out tail pipe n pulls back untill gas pedal is pushed to floor for 10 sec 1988 ford bronco 2 4x4 auto trans 2.9


Unfortunately there are several things that can be causing this issue. Try replacing your map sensor. They are relatively cheap and easily installed.

Nov 04, 2010 | 1988 Ford Bronco II

1 Answer

The engine starts but run for 10 sec. when add gas to carb.


with it backfiring i would guess the valves may need adjusting and if that does not help clean the carburator.

May 03, 2010 | Briggs Stratton 020273 Elite Series...

1 Answer

1988 Buick Century, not getting gas


by pass relay to see what happens.

Apr 05, 2010 | 1988 Buick Century

1 Answer

Bike wont run for more than 5 secs and thats when it does start


Not sure but it sounds like it's running too rich a mixture and/or your float levels are not adjusted properly. When you stopped the excess fuel has gone into the bore not burned which will wet your spark plug making it very difficult to start. Depending on the colour of the smoke it could also indicate that your mixture is too rich. For extra power you need more air not necessarily more fuel. I hope that helps you. Again not sure but sounds like that is your problem. :)

Sep 27, 2009 | 1988 Yamaha TZR 250

1 Answer

1988 Plymouth Reliant needs to be pulled somewhere...


I think about 10-15 mi less than 30 mph-library sec 629 has more info

Sep 13, 2009 | 1988 Plymouth Reliant

Not finding what you are looking for?
2000 Harley Davidson FLHR-FLHRI Road king Logo

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5060 Answers

Mike

Level 3 Expert

4354 Answers

Marvin
Marvin

Level 3 Expert

81400 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...