Question about Jianshe Motorcycles
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Hey whats up? Try back probing your wires going to the CDI unit with a volt meter or continuity tester to make sure you do have any broken wires. Then check the stater make it is good. If sure how to check the starter take it a bike repair shop they should check it for free.. If that does work let me know and I will look further into it for you. Good Luck.
Posted on May 22, 2009
SOURCE: no spark 110cc engine wont start
Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.
If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.
Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.
Please rate this answer. Thanks
Posted on May 28, 2009
Hi and welcome to FixYa,
The voltage on the green wire must be pulsating when cranking/starting the bike, not steady. Confirm by similarly testing the voltage on the black wire on the left ignition coil. If the green still reads a constant voltage, then the CDI is faulty; to be more specific, most likely that the switching tansistor inside the CDI that drives the right ignition coil has shorted.
Good luck and thank you for asking FixYa.
Posted on Jul 10, 2009
hi mate take spark plug out and put it against the engine with cap still connected and kick it over and see if there is a spark if there is it can be the electrical side if there is no spark then get back to me
Posted on Aug 25, 2009
Tips for a great answer:
Jan 06, 2016 | Motorcycles
May 27, 2014 | kawasaki 2005 KFX 400
Apr 13, 2014 | Golden Technologies Companion II Travel...
Jan 02, 2011 | Derbi Cross city Motorcycles
Sep 28, 2009 | Quad Cycling
Sep 19, 2009 | 2004 Bajaj Caliber 115
49 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: