Question about Power Motorcycles

1 Answer

I have a lifefitness engage upright bike and the console is going white when I power up. Is there any way to fix this. I've checked the circuits at the back and all seems to be in order. Any ideas?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Master
  • 2,069 Answers

You have this question in the MOTORCYCLE category. Maybe be better off elsewhere.
I had an issue with an older LIFESTEPPER. After taking the cover off the lower section and reseating the two connectors, problem solved

Posted on May 13, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Flstf 92 will only start if i am seated and the bike is upright


Hi Marty, and the usual suspects are:
1.Ignition/Light Key Switch not in IGNITION position.
2.Engine Stop switch in the OFF position.
3.Discharged battery, loose or corroded connections check negative cable at both ends. (solenoid chatters).
4. Bank Angle Sensor tripped and Ignition/Light Key Switch not cycled to Off and then back to
5. Starter control circuit, relay or solenoid faulty.
6. Electric starter shaft pinion gear not engaging or over-running clutch slipping.
7. Security alarm not disarming
If you are still having problems contact me at: xlch@mail.com
Good luck

May 25, 2015 | Harley Davidson FLSTF - FLSTFI Fat Boy...

1 Answer

Where do I plug in ac adapter


There should be a power jack on the unit, sometimes on the console, but also check the lower front, and lower rear of unit. Exercise equipment service Treadmills Ellipticals and Bikes Parts Assembly...

May 22, 2015 | Golds Gym Powerspin 290C Upright Bike

1 Answer

Why display cannot receive signal from motor main board


Check the wire harness from the console to MCB.. Most likely the wire is pinch between the frame and upright post.

Apr 09, 2015 | Life Fitness LifeFitness T3 Treadmill

1 Answer

The Fit Test and Fat Burn do not light up as an option on my Lifecycle 6500HR bike, they used to work now they don't.


This really sounds like there is a problem with your console. You might consider contacting LifeFitness for replacement options and or further troubleshooting. 1-800-351-3737 is the contact phone number for them directly.

Mar 23, 2014 | Life Fitness Nut Lock, Cranknut, Lifecycle...

1 Answer

Chain keeps comming off


Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

It sounds like you are dealing with a stretched chain. If the chain will not tension any further, you may be looking at the need to purchase a new chain. Use your model and serial number at the following link to order a new chain.

Bike Parts for LifeFitness LifeCycle 9500 Upright Belts Pedals Seats...

Jan 29, 2014 | Life Fitness Lifecycle 9500 Upright...

1 Answer

4wd will not engage even though the console light says it does.


I have an Idea. The drive shaft that is connected to the front tires may have cane disconnected inside the transmission box. Check the front and back shaft boxes.

Dec 29, 2012 | Garden

2 Answers

Dyson dc 15 brush roll not spinning. motor is good, upper switch is good.


Open the right side of the vacuum with a hex head screw driver. There are 4 screws. Inside you will find a circuit board.
1. Make sure the varistor (S20K150) is not blown, these models seem to have an issue with this. It is a flat blue "quarter" looking component near the top edge of the circuit board.
2. At the bottom of the circuit board are two white wires connected via push on connectors. Remove these from the circuit board by sliding them away from the circuit board. Power on the vacuum and engage the drive button. If the lower motor still does not engage check step 3.
3. A blue and yellow wire runs off the bottom end of the circuit board. These are the wires powering the lower motor. Check continuity with a multimeter and make sure they are not broken. I have seen where these wires will break as they run through the housing of the vacuum. If they are broken, replace them with any wire of the same gauge.

Dec 15, 2010 | Dyson DC15 Animal Bagless Upright Cyclonic...

1 Answer

Trying to replace the battery in the lifefitness 9500 HR upright stationary bike, Can't seem to locate the battery in the bike If someone could tell me where the battery is located it would be...


Tilt the bike on its side, remove mounting screws securing the battery to the bracket. Remove the battery just enough to access and disconnect the black (neg) wire from the (-) terminal and the red (pos) wire form the (+) terminal. Replace battery and reverse procedure when installing battery hope this helps you and please vote for me

Dec 04, 2010 | Cycling

1 Answer

I have a Lifefitness Treadmill model TR 9100, serial 381872. When I turn on the power switch, the treadmill does nothing. Nothing appears or lights up on the front console. I removed the motor cover and...


Ive just had lifefitness out to diagnose the same problem, its the Console PCB £413.74 all in from them to fit yourself Cant do anything else, save yourself the callout I was charged Good luck Adrian Webb 07780 993877

Jan 02, 2010 | Life Fitness 9100 Next Generation...

1 Answer

Cant get the lifefitness treadmill T7-0 to work


you may need open up the head board and check the switch.

Mar 29, 2009 | Life Fitness LifeFitness 97Te Treadmill

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Power Experts

D. E. Hev

Level 3 Expert

1175 Answers

mikeuk

Level 2 Expert

70 Answers

Lawrence Oravetz

Level 3 Expert

9742 Answers

Are you a Power Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...