Question about GAS Motorcycles

1 Answer

220 kaw four wheeler has gas new plug carb kit ajusted vals still wont start good fir

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GAS Master
  • 42,022 Answers

If it has a kill switch then check it for a circuit.

Posted on Apr 22, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2002 cr80 wont start.

Is the timing right? Check the timing.

Knight.

Posted on Apr 17, 2009

holmestead
  • 5 Answers

SOURCE: Will not run without choke

have you checked for vaccuum leaks at the intake manifold? you can check by pouring water over the gasket area when/ if you get it running!

Posted on Jun 14, 2009

  • 89 Answers

SOURCE: 91 kawaski 4 wheeler won't start

first are you getting spark?second are you getting fuel? to check the spark take out the plug and put it back into to cap(holder) do not touch the plug and turn over the engine.you will see a small spark.if not you starter coil is bad.to check the gas look under the carb there will be a overflow hose by the overflow hose is a flathead screw,open it if no gas comes out you will need to take out the carb and replace the float valve.

Posted on Jun 19, 2009

  • 75 Answers

SOURCE: gas overflow line coming from carb is pouring out on a 2001 kaw

the carb needs to be cleaned the float is stuck open and is over filling
cheap and easy fix
good luck

Posted on Jul 08, 2009

wayneman01
  • 301 Answers

SOURCE: need to see the carburetor diagram for a 2000- wont start

I could not locate a diagram of your machine's carburetor. I can tell you, for certain, that the carb does have a rubber drain tube that goes from the bottom of the float bowl and vents to atmosphere beneath the vehicle.
There are three required ingredients required for combustion: fuel, compression, and a spark (at the right time). Try to find out which of these are missing. Loosen the drain screw on the float bowl. Is fuel present? Check the compression - you've got to see at least 140 psi for anything to happen. Pull the spark plug and crank the engine. Is there a spark?
If it has sat for an extended period of time (more than just a couple of months) then the carburetor will be plugged with fuel varnish. It is very easy to think you've got everything cleaned, when the jets are still plugged up. I would take the carb apart and remove the jets. Hold them up to a light source and look through each one. If you can't see through them, there's the problem.

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 honda 500 rubicon starts good and sounds smooth at idle but boggs down when you push throttle. new gas, cleaned carb. replaced parts carb. kit also chekd TCS any ideas need help thanks R.H.


Hi, Anonymous and the usual suspects are:
1. Throttle cables misaligned or misrouted.
2. Damaged or restricted fuel tank venting system.
3. Inlet system air leak.
4. Vacuum piston malfunction.
5. Accelerator pump leaking or no output.
6. Plugged bowl vent.
7. Fuel level in bowl too low.
8. Restricted fuel supply passages.
9. Plugged jets or passages.
10. Worn or damaged needle or needle jet.
12. The enricher valve not seated or leaking.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.hondaforeman.com/128-foreman-450/74303-carb-driving-me-crazy.html
http://www.hondaforeman.com/149-honda-recon/69272-2005-recon-will-not-accelerate.html
Honda 450 Foreman backfiring no power but idles fine
Bogging out when give my four wheeler gas
http://www.hondampe.com.au/docs/owning_a_honda/owners_manuals/motorcycles/TRX500FA-FOURTRAX%20FOREMAN%20RUBICON-2003.pdf
http://ng-products.com/nic/honda/2007%20Honda%20Foreman%20Rubicon%20Service%20Manual.pdf

Apr 20, 2016 | Honda Motorcycles

2 Answers

My four wheeler gets spark and gas to the carb but wont start what else could it be?


Carb could be dirty, float stuck or choke stuck. Pull plugs, crank engine and see if you are getting raw gas in the cylinder(s). If you don't get gas to the cylinders, you won't start. You also could have a flooded carburetor.

Jun 15, 2015 | Polaris 2004 Trail Blazer 250

2 Answers

How do i re-jet my carburetors on a 2007 suzuki LT-A 400F four wheeler?


when engines not running turn the gas off . And it sounds like you need to adjust your throttle pin that goes into the carb take the clip off the pin and move it down one good luck

Nov 23, 2012 | RTO 125cc ATV Quads Full Size Adult four...

2 Answers

Hello i have a 1986 Honda fourtrax 250 2wd atv and i just bought it. the previous owner stated that he hit a ditch and it flipped. once turned back over it would not start. 2 years later i buy it and it...


Pull the carb and throughly clean it after sitting the old fuel will turn to varnish and clog everything up. also if the machine was on its top check the oil and make sure it is clean. leaking gas is a indicator that you will probably need a carb kit for it that must include the float valve and needle.

Oct 29, 2010 | Honda CB 250 Motorcycles

1 Answer

When i crank my four wheeler it wont stay running unless i pump the throttle its a kawasaki bayou 220


Try installing a new carb kit and that should help.Thanks for asking and I hope it helps

Jul 21, 2010 | 1996 kawasaki ZX-6R Ninja

1 Answer

Got a four wheeler that has spark and getting gas to carb but wont start not sure wat to do i think the valves might be stuck its a beartracker 4 wheeler not sure of the year its says 229cc


HI. YOU MAY BE GETTING GAS TO CARBS BUT IS THE GAS GETTING TO THE PISTON. IF IT WAS ME I WOULD PUT A LITTLE GAS IN THE END OF THE CARB, AND IF IT STARTS OR EVEN KICKS A FEW TIMES YOU HAVE FOUND YOUR PROBLEM. JIMBO

Aug 16, 2009 | 1979 Yamaha RD 250

1 Answer

91 kawaski 4 wheeler won't start


first are you getting spark?second are you getting fuel? to check the spark take out the plug and put it back into to cap(holder) do not touch the plug and turn over the engine.you will see a small spark.if not you starter coil is bad.to check the gas look under the carb there will be a overflow hose by the overflow hose is a flathead screw,open it if no gas comes out you will need to take out the carb and replace the float valve.

Jun 15, 2009 | kawasaki KDX 220 R Motorcycles

2 Answers

Motorcycles wont start


Your bike needs 4 things to run-Fuel, Spark, Air and Compression. One or some of these are missing.

1) Crank engine over several times to start. Remove spark plug. If plug is wet and smells like gas then it is getting fuel.

2) Check for spark
Put spark plug back into spark plug cap and lay spark end along side bolt or part of unpainted head making contact and crank over engine as if to start. If no spark then is electrical problem. Try changing spark plug. Check grounds. If not plug or grounds then purchase a shop manual from your local dealer and ohms test all electeical componet resistances as shop manual instructs. Be sure components do not meet specks before purchasing.

3) If has spark and plug was wet upon removal then gas has water or just old gas. If you drained the carb via bottom of carb screw into a clean clear container and see stuff at the bottom then carb is dirty with water and or dirt.

If your bike has been sitting along time condensation will build explaining water and or gas will loose its kick after sitting too long. If you think it has been sitting a long time it is best to dispose of old gas and refill with new. Water can also get into tank from gas can when fully tipped upright so dont dump every last drop into the tank...most ofter the last couple of cups are water.

If bike has been sitting for a few days and was running fine before that, turn off gas, drain carb via bottom of carb screw, close off screw and turn gas back on. This will refresh the gas in carb.

If none of these are the case and you have good fuel, good spark...check air filter for air flow. If all this is good then you need to do a compression check. A simple way to do it is to stick your finger in the spark plug hole and hold it in there with some force and have a friend try to start the bike. If it blows your finger out then it has compression. If it doesnt want to force your finger out then you have no compression and is a piston and ring problem. The only way to test compression for sure it to purchase a compression tester from auto parts store that has an adapter for your size plug hole and do a proper test. I hope this helps.

Apr 08, 2009 | 2002 Honda CR 125 R

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top GAS Experts

Ron Rak
Ron Rak

Level 1 Expert

47 Answers

rugby prop

Level 3 Expert

570 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Are you a GAS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...