Question about Honda Motorcycles

1 Answer

Honda WRX 125 Mo-Cycle How to read dipstick for oil

Has a blacK plastic screw in Cap/with dipstick no marks on Dipstick

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 775 Answers

Hi,you must make shore that the oil is covering the dipstick by about 10 ml,sometimes there is a little round window in the casing if so just make shore the oil is harf filled in the window,(not all have the window)
hope this was some help.

Posted on Apr 19, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What oil viscosity and how much on my simpson pressure washer msv 3024

Here's a link to your Simpson manual:
No oil is required for the pump.

10W-30 is normally specified for a Honda GCV160-GCV190 engine. You drain the oil by removing the oil cap/dipstick and then tilting the machine on it's side so that the oil can drain out if the oil fill into a container. (Drain when warm so it flows easily).

The capacity of the engine is ~18.6 oz. Refill amount is ~12.0-13.5 oz. (either engine).

When refilling, add oil and check on dipstick often. To check, press the dipstick into the oil fill, but DO NOT SCREW IT DOWN. Just insert the dipstick in until it contacts the top of the oil fill. The correct reading is between the lower and upper limits marked on the dipstick. (You may have to look carefully to see the marks).

Dec 27, 2015 | Simpson Garden

1 Answer

WRX/2014 Screw in Black plastic Lug/dipstick where should the oil level be for full

if it doesn't have a upper line but a series of xxxxx on the stick then full is when the oil is on the uppermost x

Apr 19, 2015 | Honda Motorcycles

1 Answer

Oil Dipstick has no marks what is the required level

It would help to know more about what you have.
Year Make Model & engine size

Apr 19, 2015 | Cars & Trucks

1 Answer

Oil Level on dipstick Honda

With the cap sitting on top of the hole, oil should be between marks on dipper.

Apr 19, 2015 | Honda Motorcycles

1 Answer

How to check engine oil in scooty pep plus

Locate the oil dipstick which will be made of black plastic with a raised lip for turning. The dipstick will either be under the seat on the top of the engine or on the lower side of the engine. Once located, unscrew and wipe off excessive oil. Reinsert dipstick but do not screw it in, then remove the dipstick and hold it horizontal to read the level, which should be between the two marks on the end. If the oil level is near the bottom mark, add enough oil to increase it as close to the top mark without exceeding the top mark.

Oct 08, 2012 | 2011 TVS Scooty Pep Plus

1 Answer

How do I check the oil on my Yamaha 2003 ttr 125? Do i screw the dip in or not?

I'm not exactly sure with this model, but my yamaha has the dipstick on the filler cap and NO you dont wind it in, just put the dipstick in as far as you can without screwing it in and then remove it and read the level.

Jul 15, 2011 | Yamaha TT-R 125 Motorcycles

1 Answer

What level should the engine oil on loncin lx 125-2 should be

The motor is based on the Honda 50/70/90 motor. I'm not certain of the oil capacity but I do know this- The dipstick is not screwed in to check the oil level. Unscrew it, wipe it and dip it into the crankcase (don't screw it in)for the correct oil reading. Honda states oil capacities of between .8 and 1.0 liters.Should be pretty close but don't overfill it.Good luck!

Jun 11, 2011 | 2006 Loncin LX 125

1 Answer

How to check autogearbox oil level on 2005 mercedes cls 320

If your car with 5 speed automatic transmission there are special dipstick for it, it only have with dealers workshop, drive there and ask them need to check trans oil, if u found right dipstick you can check it your self, trans mission dipstick tube locate at back side the engine at right of middle, dipstick tube have covered by black cap with read lock, first you have to brake read lock and push remain read plastic lock inside the cap by small flat screw driver, and open cap, then keep engine running and check oil level if your car trans oil cold it should be the cold level on dipstick for check trans oil you must have better knowledge for that it mean oil level be deference and deference temperature better ask mechanic to check it, if your car have the 7speed trans mission you can't check oil level because it's need to plug diagnostics computer in to the your car and get trans oil in to 45 degree temperature, The oil temperature can check only diagnose CPU and also after rich the 45 degree temp need to open drain plug screw and check level for do this must need to get experience technicians service, is this information helped you?

Oct 20, 2010 | Mercedes-Benz CLS-Class Cars & Trucks

1 Answer

How to add automatic transmission oil for 2001 mercedes s class ? is it from the small choke near the back of air filter?

yes first remove the air cleaner housing witch is black plastic big housing with two air duct connect to front cross member pulling upwards have a look back right hand side the engine bay behind the engine you can see black small tube, it have covered by black cap with read lock you have to pull and brake read lock to open the cap some model have oil dipstick tube also near that be careful open the right one transmission dipstick tube shorter than oil dipstick tube you have to open shot one if you have good look you can see it's going to transmission or engine for adjust transmission oil you have to check transmission oil temp and you need right dipstick for that the dipstick only have with authorized Mercedes service center maybe could find from other workshops too not sure for check oil temp you need a diagnose cpu.

Jul 13, 2010 | 2001 Mercedes-Benz S-Class

2 Answers

Changing the oil in a 2004 Honda CRF230F

The oil filler hole cap has an oil dipstick. Fill to mid range on the dipstick, about 2 quarts, just watch the dipstick. By the way, do not screw the dipstick in when checking oil level. Your bike does not have an oil filter. Use 10w40 motor oil in the gear box. Don't use any synthetic oils, oil marked "EC", or oil with "special" additives. Stick with the major brands; Pennzoil, Quaker State, Mobil or Shell.

Jun 05, 2009 | 2004 Honda CRF 230 F

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers


Level 3 Expert

76630 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides