Question about Honda Motorcycles

1 Answer

Why does my 20a fuse for my fuel injector keep burning out on my Honda cbr 600rr when I try to start it

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 44,434 Answers

Probably because there is a circuit problem and the main start current is going through that fuse instead of to the starter solenoid.

Posted on Apr 14, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
rockitman187
  • 2559 Answers

SOURCE: my honda cbr 600rr 2005 will not start the hiss

1. Obtain a new transponder key.
2. Grind the key in accordance with the shape of the original key.
3. Apply 12V battery voltage to the ignition pulse generator lines of the engine control module (ECM).
4. Turn the ignition switch ON with the original key. The immobilizer indicator comes on and it remains on.
*The code of the original key is recognized by the ECM.
*If there is any problem in the immobilizer system, the system will enter the diagnostic mode and the indicator will remain on for approx. ten seconds, then it will indicate the diagnostic code (page 20-5).
5. Disconnect the red clip of the inspection adepter from the battery positive (+) terminal for two seconds or more, then connect it again. The indicator remains on for approx. two seconds, then it blinks four times repeatedly.
*The immobilizer system (HISS) enters the registration mode. Registrations of all key except the original key inserted in the ignition switch are canceled. (Registration of the lost key or spare key is canceled.)
NOTE:
The spare key must be registered again.
6. Turn the ignition switch OFF and remove the key.
7. Turn the ignition switch ON with a new key or the spare key. (Never use the key registered in previous step.) The indicator comes on for two seconds, then it blinks four times repeatedly.
*The new key or spare key is registered in the ECM.
*If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain on for approx. ten seconds, then it will indicate the diagnostic code (page 20-6).
CAUTION:
Keep the other transponder key away from the immobilizer receiver more than 50mm (2.0 in).
8. Repeat the steps 6 and 7 when you continuously register the other new key.
NOTE:
The ECM can store up to four key codes. (The four keys can be registered.)
9. Turn the ignition switch OFF, remove the inspection adapter and connect the ignition pulse generator connector.
10. Turn the ignition ON with the registered key.
*The immobilizer system (HISS) returns to the normal mode.
11. Check that the engine can be started using all registered key.

If that doesn't work,You will need to go to a dealer and have the keys reprogrammed.

Posted on Jun 04, 2009

Benimur
  • 6966 Answers

SOURCE: I am putting a cbr 600rr motor into a 2006 yfz 450

Hi and welcome to FixYa,

Have you tried here?

Good luck and thank you for asking FixYa.

Posted on Nov 04, 2009

  • 45 Answers

SOURCE: how to install no cut frame sliders on 2005 honda

One at a time, Make sure to use a manual and torque wrench set to the right value.

Posted on Feb 07, 2010

voices122
  • 12 Answers

SOURCE: my honda cbr 600 wont start and keeps backfireing

Check your plugs. If all four are sparking then your carbs are out of sync. They will need to be re-balanced.

If you are capabable in doing this job your self, you will need a screwdriver that fits your adjuster screws and a CarbTune Carb balancer.
Remove your tank and airbox.
You should see the flaps inside your carbs. These should open when you move your throttle.
Start on the outside carbs to get them balanced with the 2 centre ones.
To start, unscrew the adjusters all the way out. then screw them in until the 2 outer carbs move at the same time as the inner 2 carbs
Once this is done then adjust the centre balancer to syncronise the 2 left hand carbs to the 2 right hand carbs.
Now if you have done this correctly, all four carbs should open at the exact same time.
If you have a Carbtune balancer, remove the plugs from the top of your inlet manifold and plug in the hoses from the carbtune balancer.
Start the engine and adjust the screws until the weights inside the Carbtune balancer all read the same.
Once done, remove the balancer, replace the plugs into the inlet manifold, refit the airbox and tank and it should run so much better.

If your not 100% confident to unertake this job yourself, take the bike to your local dealer and ask to have the carbs balanced.

Posted on Mar 15, 2010

sisadsl
  • 1508 Answers

SOURCE: CBR 1000rr wont start

check for spark, make sure the test plug is grounded to the engine or it can damage electrics

Posted on Apr 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blows fi fuse


Check the injectors for short circuits. It might have been the injectors that ran the battery down to begin with.

Nov 24, 2013 | Honda cbr600rr cbr 600rr 08 09 10 11 12...

1 Answer

1987 CBR 600 will not start when hot


Hi, Anonymous and the usual suspects are:
1. Faulty ignition coil.
2. Faulty spark plug cables.
3. Faulty temperature sensor.
4. Faulty starter motor.
5. Valves adjusted too tight.
6. Spark plug gap too wide.
7. Fuel has vapor lock.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Wont start when hot slow crank like battery dead but not dead CBR Forum...
04 600rr Won start when hot starts fine when cold
http://www.home-business-host.com/images/cbr/CBR1000F%20SC21%20(1987-1996).pdf
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600F Owner Manual

Jul 29, 2013 | 1987 Honda CBR 600 F Hurricane

1 Answer

2012 Honda CBR 600RR service manual


Hi, Anonymous the vast majority of service, parts fiche, and owners manuals on the internet are "FREE" to download and all service manuals contain wiring diagrams in the back pages. The rest usually charge a modest fee of $15 and there is a handful of obscure, rare, obsolete, and very old models that are no longer or never were available and some were never printed in English. The Indian and Philippine markets are usually in E-book format only, for these rare occasions I shall look on eBay and find the cheapest one available. Most of the manuals will cover your exact make, model, and year otherwise one will be provided that comes as close as possible to your bike and will have most of the same info that an exact manual would have. If there is no $ sign after the manual link it is free to download.
To download your manual for viewing or printing please click on the blue links below. Good luck and have a wonderful day
Honda 2013 2014 2015 CBR600RR CBR 600RR RA service manual Download Manuals... $27
https://www.partsfish.com/page/oem-parts-for-honda
2014 Honda CBR600RR Owner Manual
Honda CBR 600RR
Honda CBR600RR Wikipedia

Jan 31, 2013 | 2012 Honda CBR 600RR

1 Answer

Need ignition wire diagram for honda cbr 600rr


Sorry to hear... really!! ... borrow a trailer or pick-up and knows what they are doing.

Jun 09, 2012 | 2004 Honda CBR 600 RR

1 Answer

Looking for 2003 Honda CBR 600 RR wiring diagram.


Honda CBR 600 RR Service Manual COLOR WIRING DIAGRAMS Inlcuded with the Honda CBR 600 Service Manual
Models covered: 2003 2004 2005 2006 HONDA CBR600RR CBR 600RR 600 RR

http://hondamotorcyclestore.com/honda-cbr-600-rr-service-manual


Mar 16, 2011 | Honda CBR 600 RR Motorcycles

1 Answer

HOW DO I KNOW IF THE FUEL PUMP ON MY 2007 600RR IS NOT WORKING


if your fuel pump is not working, then your bike wont start

May 20, 2010 | 2007 Honda CBR 1000 RR Fireblade

1 Answer

I am putting a cbr 600rr motor into a 2006 yfz 450


Hi and welcome to FixYa,

Have you tried here?

Good luck and thank you for asking FixYa.

Nov 04, 2009 | 2005 Honda CBR 600 RR

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...