Question about 2006 Suzuki Boulevard C90T

1 Answer

Wont start no lights 2006 suzuki c90 t

2006 suzuki c90 t trun on key hit starter lights go out wont start nouthing works

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 20 or more questions within one hour.


    An expert who has answered 20 questions.

  • Expert
  • 112 Answers

Battery is dead or no capacity. Check charge. A battery can read correct voltage but have no capacity. battery should be 13.8 volts fully charged approximately.

Did this just happen after storage or was it working fine then had the problem>? Needs more details and history to diagnose. How old is the battery??.

Posted on Apr 13, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 Suzuki Boulevard C90 computer reset

Hi, Nelly for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Suzuki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
re setting Suzuki Volusia Forums Intruder Volusia and Boulevard Forum
REsetting Wee Tip Over Sensor
Suzuki VL1500 Service Manual
Suzuki Intruder VL1500B Owner Manual

Mar 14, 2018 | 2006 Suzuki Boulevard C90

1 Answer


Hi, Bubba and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a "LOAD" test, your battery may show 12.5 volts but has little or zero amps and must be replaced.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand or clutch pull in switch/sensor.
10. Security alarm needs a reset.
11. Starter control circuit, relay, or solenoid faulty.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
2005 C50 won turn over FOUND THE PROBLEM
06 Suzuki Boulevard C90 won turn over
Suzuki VL1500 Service Manual
OEM parts for Suzuki
Suzuki Intruder VL1500B Owner Manual

Mar 23, 2017 | 2006 Suzuki Boulevard C90

1 Answer

Turn key on turn kill switch to on position i hear fuel pump pull clutch in then hit starter button only a whirring sound not clicking and wont start has a new battery Suzuki boulevard c109rt

Hi, Kurt the starter drive/Bendix is a mechanical gear driven component that engages the clutch pack ring gear to turn over the engine. It has an internal mechanism that allows the gear to turn in one direction and once the engine starts allows the drive gear to free spin. If gear free spins in both directions then the drive gear has failed it is not serviceable and needs to be replaced. For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have nice a day. Bike wont start makes buzzing noise
OEM parts for Suzuki
Suzuki Boulevard C109RT 2012

Mar 16, 2016 | Motorcycles

1 Answer

2006 suzuki c90 t trun on key hit starter lights go out wont start nouthing works

Begin with checking the fuse, then an inspection of the cable ends, then the relay. Perform a voltage check before and after the relay and chase the voltage down to where it stops/fails to go. If you make it all the way to the starter with good voltage then the starter is bad. You'll be checking bother the big wire, and the smaller one which energizes the starter. The smaller one interacts with safety switches at the kickstand, clutch and gearbox.
Take your time and work from the battery to the starter.

Apr 13, 2015 | Suzuki Motorcycles

1 Answer

I have a 06 c90 and my FI flashes and the bike wont start.If i turn the key on and immediately hit the start button it willl star,but only for 5 seconds.if i start bike and get the revs up it will stay...

F1 is only saying check fault codes, you should have a small whith block connector some where under the seat, u need to use a bit of wire, place in the terminals like arc out, and then turn ignition on, on the dash it should show a fault code, if 00 no faults so look into fuel filters, blockages, water in fuel tank.

Jul 28, 2014 | 2006 Suzuki Boulevard C90T

1 Answer

Battery dead after ride.. wont start.. 2006 C90

COuld be a bad battery or there is a loose (or corroded) connection somewhere. Check to be sure everything is tight, and clean on the battery terminals. If this happens after short trips, or after trips when your bike sat for a while, or on colder days it's probably just time for a new battery.

Jul 26, 2013 | 2006 Suzuki Boulevard C90

1 Answer

Add lightbar to 2006 suzuki c90 stock warning?

As long as the lightbar's power is less than 50 Watts and you secure it with it's own seperate fuse (5Amps for 50 Watts) I believe you don't have electrical issues. Use seperate lines directly from the battery and use a switch to turn it on only when your engine is running. Of course you may have warranty issues with your dealer if you install it.

Feb 05, 2012 | 2006 Suzuki Boulevard C90

1 Answer

Engine wont turn over on my gv 2006

The 1st thing i need to do is clarify what you mean by "won't trun over" do you mean the starter motor spins the engine and it will not fire up or that the starter doesn't trun the engine over? If the starter doesn't turn the engine over do you hear a clicking coming from the starter solenoid when this happens? If so replace the starter solenoid the heavy electrical contacts are burned.

Dec 28, 2011 | 2006 Suzuki Grand Vitara

1 Answer

Suziki Boulevard C90 wont start, when hitting the ignition nothing happens, but the lights dim

Your starter button is a two position switch. The lights are supposed to go dim when the button is pushed halfway in. When pushed in all the way it should activate the starter solenoid. The starter solenoid is located under the seat next to the battery. You can follow the positive battery cable directly to the starter solenoid. If you push the starter button and the starter solenoid clicks, then the starter button is good. If the you unplug the two smaller wires going to the starter solenoid and connect a voltage meter to the main harness leads , the needle should jump whenever you press the starter button. If it does not clean the button contacts or replace the right switch assembly. If the starter button is good then take a jumper wire and short across the two battery cables on the starter solenoid. This will put power directly to the the starter. If the starter works now replace the starter solenoid. If your starter still does not work, try holding the starter button and tapping on the starter with a plastic hammer. If the starter works now then you probably need to replace the starter brushes. If anything else is wrong with the starter you will need to replace the assembly as the dealer will usually only offer the starter brushes for repair purpose.

Jun 18, 2011 | 2005 Suzuki Boulevard C90

1 Answer

My 2006 Suzuki c-90 won't start. We I turn the key the power relays all fuction properly. Next, I hit the electric starter button and nothing.

check cut/safety switches . not sure about the circuit on this model but could be the side stand switch or the brake switch (on the handle bar)also check the rear tail light bulb is working when brakes applied. good luck...spaz.......Regards.....tabbycat

Jun 13, 2009 | 2005 Suzuki Boulevard C90

Not finding what you are looking for?
2006 Suzuki Boulevard C90T Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

78919 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4818 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides