Question about Gilera Motorcycles

1 Answer

My speedo dosent work on my gilera runner but the cable is ok wot could it be

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 496 Answers

Hi the easiest thing to check is the spedo drive at front wheel lift front wheel off the ground and spin wheel if you look in where the cable goes you should see it turning. If not the drive needs repair or replacing. Regards Jim...

Posted on Apr 10, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: my gilera runner 07 plate 50cc wont start

any 2 stroke oil

Posted on Apr 18, 2009

  • 3 Answers

SOURCE: misfiring at speed on gilera 200 scooter

This sounds more like a lean fuel condition than ignition. If it was stored over the winter without the gas being drained or a fuel stabilizer being added, you'll likely have varnish build-up in the fuel system that is not allowing sufficient fuel flow.  If your engine is fuel injected, it's likely your injector is partially clogged.  If it's carbureted, your carb jets may be partially clogged or your carb float may be sticking and not allowing the needle valve to fully open.  Fill the gas tank with fresh gasoline, but leave enough room for a can of Sea Foam.  The Sea Foam may be able to break up the deposits and allow fuel to flow again.  However, there's no guarantee and the fuel system may have to be disassembled to be cleaned.

Posted on May 05, 2009

  • 167 Answers

SOURCE: indicators and horn stopped working

have you checked the switchs?..all wires are on them..& 1st check the fuse as not blown...the regultor charges the battery....so if the battery is fully charged the indicators & horn should still work..i would look for a wireing fault 1st...hope this helps

Posted on Jan 26, 2010

  • 5 Answers

SOURCE: i snapped my drive belt on gilera runner vx 125, how do i change?

take side casing off on engine then take variator off then change it

Posted on May 16, 2010

  • 1 Answer

SOURCE: Gilera runner sp50 - engine turns over but does not start

i have a gilera dna 50 it was working perfect yesterday and all of a sudden its turning over it wants to start but wont ?

Posted on Mar 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

To anyone out there ive got a gilera runner vx 125 ,2001 ,just spent 2500 on it ive put malossi 210 kit with polini, clucth, belt ,and variator on it with 8 and 10 gram pm rollers ,also polini tourqe...


Hi, Jmb76252 let me see if I understand you correctly you have taken a 125cc scooter designed for pleasure and around town commuting and excellent fuel mileage thrown a ton of money at it in aftermarket performance parts that may not be compatible with each other and expect a ground pounding, wheel standing, flaming burnout machine that it was never designed for in return? This type of R&D is way above my pay grade perhaps an appointment with the Gilera racing team would be in order. Good luck and have a wonderful day.

Apr 09, 2017 | 2005 Gilera Runner VX 125

1 Answer

Speedo not working,only shows 0 mph at all times [Gilera 125] scooter


check the wiring under the front mud grade there is a nother cover and it get cut

Jun 15, 2010 | 2005 Gilera Runner VX 125

1 Answer

There dosent seem to be any fuel getting from my tank to the carb on my gilera runner vx 125. what do i do please help


the valve is on ... right? There may be a strainer or other kind of filter ... check it. If that is clear, remove the hose from the valve ... gas? if yes and still no run, remove the hose from the carb ... gas? still no run ... problem with the float or something else in the carb.

Apr 29, 2010 | 2005 Gilera Runner VX 125

2 Answers

Gilera runner sp50 - engine turns over but does not start


you went through the electric. system, now check fuel supply filter, tank, valve carb bowl for dirt

Aug 08, 2009 | 2005 Gilera Runner VX 125

2 Answers

Lacks power bike starts up ok but has got no power this bike is a 1998 gilera runner 49cc


u mite need a top end rebuild-new rings or valves-have a compression test done or it may need a electrical or carb toonup

Jul 31, 2009 | 2005 Gilera Runner VX 125

2 Answers

Hi ppl i have got a gilera dna 125cc and it will only go past 28mph and won't go past 7000revs but if i rev it to 7000 and put my finger in the carb in push the niddle up it go's past wot can this...


try adjusting the cable adjuster on the top of the carb. it may be loose and worked it way down
does the throttle cable feel loose when you pull on it?

Jul 21, 2009 | Gilera Runner VX 125 Motorcycles

1 Answer

My speedo an my millage stopped working on my gillara runner 125 what do i do to check it


Unfortunately, unless you're a wizzard you'll need to get you're mechanic to change the speedo drive, the lead you see coming out of your front wheel area. Don't know how much it cost's as my mechanic did the damage in the first place!

Jun 16, 2009 | 2005 Gilera Runner VX 125

1 Answer

Gilera 125vx speedometer milage counter and front light problems


u front clocks have blown find a replacement and fit u should find it works all fine again

May 20, 2009 | 2005 Gilera Runner VX 125

1 Answer

How do i fit a new brake cable to my gilera runner 125


hi disconnect both ends tape new cable to old one and pull through reconnect ends and adjust
hope this helps ian

Mar 25, 2009 | 2005 Gilera Runner VX 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gilera Experts

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Are you a Gilera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...