Motorcycles Logo

Related Topics:

A
Anonymous Posted on Apr 04, 2015

I got a 2006 kawasaki vulcan 550, putting starter on, whats the best way to get it to line back up with the gear,it keeps moving alittle)with out tearin it apart

1 Answer

jimcatherina

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Master 575 Answers
  • Posted on Apr 04, 2015
jimcatherina
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Dec 27, 2010
Answers
575
Questions
2
Helped
127839
Points
1599

Hi the cover must come off they are very difficult otherwise. Regards Jim...

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the fuel line on a Vulcan 500 2006 to drain the tank

The fuel on/ reserve adjustment (fuel petcock) is on the bottom left side of the tank opposite the key switch and near the choke. The fuel line extends from that and will drain the tank if you remove it. You will likely want to remove the tank if you plan to drain a lot of fuel. That will make it a little less messy
0helpful
1answer

1999 Kawasaki Vulcan 1500 Nomad engine oil capacity

there a small bolt missing on the front of my kawasaki 1500 nomad that r not there and a little fuel come out from time to time do u no what it call so i can get another one to put there ? and after changing the oil bike wont shift gears help ? only first gear
0helpful
1answer

I have a 1995 kawasaki vulcan 500, i am looking to find a wiring diagram, because i put the key in and no start/lights/or fire, i need to check all the lines to make sure everything is ok?

Not sure if it helps but I have had lots of problems with my switch gear. If I fiddle with it and keep trying to turn it on eventually 'I find the ignition lights up !Z!
1helpful
1answer

1992 500 vulcan, Starter will not engage. I have to put bike into gear and roll engine over a bit, then slip back into neutral and hit starter and then it will engage. This is a intermittent issue.

Try blowing out the starter motor with an air line a build up of dust can make it stick, If this wont work and it may not. then take it appart and check for wear the gear should not wobble on the shaft . Finally a good clean and grease should sort it
1helpful
1answer

Whats the adjustments on a 1996 kawasaki vulcan 800 carburetor. the bike seems to blacken the plugs and run sluggish. it was rejetted however im not sure if the carb was adjusted for the new jets. im...

oem specs run lean if you rejetted and plugs are blacken running rich try air screw first alittle at a time (replace plugs) keep rechecking plugs as you go same diff. if you adjust fuel screw
Not finding what you are looking for?

48 views

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...