What is the hub nut torque spec for 2011 Dodge Journey?

https://www.chevyhhr.net/forums/problems-service-repairs-42/wheel-hub-assembly-axle-nut-torque-spec-38394/

Is the hub bearing, seal & race in good shape?

Question edited for clarity.

6 to 8 ft lbs. It is so little is is measured in INCH pounds. 72 in/lbs is the torque, which equates to 6 ft/lbs.

2015 Dodge Journey 3.6L Engine Torque Specs

dodge-specs.com https://dodge-specs.com > cars > 2015 > journey3.6

The intake manifold bolts can be torqued down to 8 ft-lbs regardless as to whether it is the lower or upper manifold. The ignition coil assembly can be torque ..

..

The torque specification and the sequencing is as follows:
1. Brake caliper bracket bolt (front): 190 N.m. , 140 Lb-ft
2. Hub to axle shaft nut: 205 N.m., 157 Lb-ft
3. Hub to knuckle Bolts: 100 N.m., 74 lb-ft

The hub bearing retaining bolts are 150 ft. lbs the center axle nut primary torque 135 ft.lbs rotate 5-10 times increasing torque by 50 ft.lbs until final torque of 265 ft.lbs is reached

The torque for the hub bolts is 120 ft. lbs
The torque for the axle nut is 185 ft. lbs.

Here are the torque specs you seek:
• Caliper mount bolts are to be set at 74 ft-lb
• Driveshaft axle nut should be at 177 ft-lb
• Hub and bearing mounting bolts should be at 133 ft-lb

Here are the specs you're looking for:
• Font axle to hub nut torque 185 ft-lbs
• Front hub bearing bolts 60 ft-lbs
• Caliper housing bolts 125 ft-lbs
• Caliper guide bolts 26 ft-lbs
• front spindle hub nut 97 ft-lbs
• lug nuts 100 ft-lbs.

Spindle nut. Tighten the nut to 185 ft. lbs. (251 Nm). Inch pounds is not an option, this critical torque spec is FT lbs.

If you are looking for the spec on the large nut for the CV axle to hub it is 180 ftlbs