Question about Motorcycles
Posted by Anonymous on
Check the front tire for uneven wear or out of round. Block the bike so that the front wheel is off the ground and rotate it to see if the rim or tire are out of round.
It may just be that it needs to be balanced.
Definitely track it down. Not a good way to ride.
Posted on Mar 31, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 HONDA SHADOW ACE 750 CARB
It sounds like you may have or will be jetting your carbs. I did this using the directions with the kit and used the Clyman manual for this bike to show me step by step how to remove the carborator. You will only need to attach 2 of the 4 hoses on your carb. syncronizer. If I remember right, you need to remove the bolt-on cooling fins to expose the engine block. The is a black screw or bolt that you take out and screw the threaded metal adapter of the sync tool. Be careful using the sync tool. Be very light on the throttle or the vacuum in the cylinder will **** in the mercury from the sync tool - not good. The problem you are stating on idle & backing off sometimes happens when the carbs are running rich (too much fuel) Hope that gets you in the right direction.
Posted on Oct 03, 2009
You need a long reach plug wrench tool should have one in your bikes tool kit .
Posted on Mar 17, 2010
Testimonial: "I didn't realize the correct tool had been under my **** all these years. Thanks for the help!"
A single bolt holds down the back of the passenger seat. Take it out and lift the back of the seat and pull it off toward the back of the seat. This will expose the bolt at the back of the driver seat. Remove the bolt, lift the back of the seat, and pull it toward the back of the seat to remove it.
Posted on Dec 29, 2010
Maybe I am missing somethtg here ... you press the start switch and one of 2 things happens - the bike starts or it doesn't. If it does, your start switch is definitely good. If it doesn't ... well there are a couple things to consider. Are you in gear? Will not start in gear unless the clutch is pulled in. But, if the clutch is pulled in and you are in gear and the side stand is down, it will not start. So, if you move the side stand up, you are in gear and you have the clutch pulled in and it doesn't start ... well ... could be the key is not on (silly but true) and/or the 'kill switch" may be in the off position causing your bike to not start. If the clutch is pulled in, the side stand is up and you are in neutral and the kill switch is in the run position and the key is on - (or some other very similar arrangement as I have described) your Shadow should start. Nothing here has ruled out a bad switch nor, for that matter, a good switch.
You bike will still not start - so what else to look at/for. How is the battery? Have you checked it recently? Your battery MIGHT still be the original in which case I would be suspect of it being 10 years old. Maybe you or a previous owner has replaced it ... still, have you checked it? You will find it under the seat.
Battery good and still will not start? Find the start solenoid. With a volt meter, measure the voltage at each of the large terminals. One shold be 12 volts (battery side) the other should be zero volts (starter side). You will check the smaller terminals later . Key Off? No volts on smaller terms. With everything in a normal start condition (key on, bike in neutral, kill switch in run position), measure the voiltage on the other large terminal on the start solenoid. Should be zero. Press the start button. Do you get voltage? No voltage = the solenoid is either not receiving power to energise or it is energised but not making connection.
What happens is when you turn on the key you supply power to potentially anything that can be turned on. When you press the start button, you should be powering the start solenoid (an electric operated switch) That should allow power to flow to the starter and start the bike. If all that is happening, I would suspect the starter. If everything is OK but it doesn't start, suspect the solenoid and lastly ... the switch. I think I would consider jumping power directly to the starter to see if that actually runs before looking at the switch. The actual start switch is pretty tuff compared to other parts of the system.
Let me know what happens ... good luck. I think you will find something simple.
Thanks for your question @ FixYa.com
Posted on Sep 12, 2011
Testimonial: "Great suggestions to help me resolve my issue"
Tips for a great answer:
Dec 27, 2011 | 2001 Honda VT 1100 C Shadow Spirit
Nov 17, 2010 | 1995 Jeep Grand Cherokee
Jun 19, 2010 | 2002 Honda VT 750 CD Shadow A.C.E. Deluxe
May 25, 2010 | 1999 Honda VT 750 CD Shadow A.C.E. Deluxe
Apr 10, 2010 | 1997 Jeep Grand Cherokee
Mar 17, 2010 | 1998 Honda VT 750 C2 Shadow
Sep 25, 2009 | 1995 Ford F150 Styleside Regular Cab
May 03, 2009 | 1998 Dodge Ram 1500 4WD
Apr 18, 2009 | 2002 Honda VT 750 CD Shadow A.C.E. Deluxe
80 people viewed this question
Usually answered in minutes!