1994 Mazda ute how do I adjust clutch cable

no adjustment
if it is slipping replace the clutch mastery cylinder if hydraulic or clutch cable if cable operated

The clutch is hydraulic and is self adjusting (no adjustment provide for). If you have clutch engagment problems your clutch is most likely worn out.

Hi this is a common problem with new or old hydraulic systems.If the hydraulic system has no leakages, no rubber reinforced hoses swelling under pressure. It will be correct to replace clutch master and slave cylinder .Do observe the condition of clutch and pressure plate, This seems to be a case of internal pressure loss .

is fluid level ok? if so you may need a clutch master cylinder, that is if its a fluid clucth. it may operate by cable, in tyhis case it may be adjusted or it may be broken

Timing out by a little bit? Not a rotary is it ,cam belt or chain dont know what mx3 has being a tooth off correct position caused by tensioner ?or a sensor crank or cam ,needs pluging in to a reader or if its early ecu may flash led with fault code.hard when cars on other side of world

There is a pin that connects the clutch pedal to the clucth master cylinder. It sounds like this pin fell out. It is just a matter of lining up the hole in the master cylinder with the connector off of the clutch pedal. Push the pin in and install a new cotter pin to secure.

If it has a clutch cable,it needs adjusting,if it does not,then bleed the hydraulic slave cylinder.

can assist with master cylinder and slave cylinder layout isuzu bighorn bj2

You should be able to hook it up yourself. Don't forget to adjust the clutch when you are done.