Are you referring to the drain plug? if so, it is located on the passenger side bottom facing the front bumper. see attached diagram under radiator removal. http://www.kia-forums.com/attachments/kia-carnival-sedona/9678d1319024147-removing-radiator-kia-sedona-2005-remove-radiator.jpg
SOURCE: where is the crank position sensor located in 2005
Hello martinezmelm: My name is Roger and I can answer your question. To locate the crankshaft position sensor. You will need to remove the timing cover. You will find the sensor on top of the crankshaft gear. Between the V of the timing belt.
Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger
SOURCE: Where is the input speed sensor on KIA sedona 2005
on transmission has 2 wires at right side of trans .by axel
SOURCE: How do change the serpentine belt on a 2005 Kia
There is a tensioner pulley that has a nut in the middle of it, loosen that nut and there is a tensioner bolt that when you loosen it, it slides the pulley away from the belt to replace it.
SOURCE: How do I bleed air
The cooling system of 2003 Kia Sedona does not have any air bleeding valve. Though you can bleed air from cooling system by lifting the front of the car, after filling at full level the coolant reservoir under bonnet. Then start the engine and let it run until it reachs the high end of normal range of the temperature gauge. Now stop the engine, and flow cold water over the radiator core, in order to siphon off the air from cooling system. Now the coolant will be absorbed from the reservoir, and air bleeded from cooling system. Repeat this process if necessary. Pay attention to keep full with coolant the reservoir under bonnet. Never let it empty, otherwise this will insert more air into the cooling system!
SOURCE: Where is the evap purge canister valve located on
The canister purge valve is located behind the intake manifold in the engine compartment on the firewall side .It should be a small round solenoid with a wire connector attached.It will have a feed hose from the evap cannister to the purge valve and then to the intake manifold.The evap canister is located on under the vehicle on the right side of the gas tank and is held in place by a bracket.If you follow these hoses it will also get you to the canister purge valve.I hope this helped.
1,193 views
Usually answered in minutes!
×