Question about Motorcycles

1 Answer

Sled was runing for about 2min. i turned it off now will not start.

Tride to start it again and it let a backfire out and now it will not start. it will just turn over. what would it be?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,249 Answers

Out of gas sled was runing for about 2min. i turned it off no - 25315266-wng3opgl1pug32fsc4t4fc4i-4-0.jpg

Posted on Dec 10, 2014

Testimonial: "full tank of new gas"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sled runs but backfires could stator be bad


Backfire usually means bad timeing of valves or ignition. Could be a timing belt jumped possition, or is badly worn. Last time factory recommended service performed?

Mar 06, 2015 | Motorcycles

1 Answer

2008 vector ltx. i started it and ran for about 2min. i shut it off and went to start it again and it backfired and now just wont start. just turnes over.


clean your plugs , are you getting fuel , ck that first , if they have a electric pump in the tank ck the fuse

Dec 10, 2014 | Big Motorcycles

1 Answer

Engine missing


Take it to Dealer.

Feb 14, 2014 | Yamaha Winter Sports

1 Answer

I have a 2005 fusion 900 and ran great till the wire coming from left side of crank case wore threw and sled quit so I fixed the wires and sled would run good for 20 30 min shut it off and it would have no...


If still wired and starts then dies take a small hammer and tap on back of starter as a friend cranks it over if it fires up then the seilnoid is bad if all in one if separate try tapping on it you can also run battery cable to starter positive neg to batt positive to big nut on starter if starts then seilnoid basic all in one replace whole thing also check all grounds and terminals are tight also don't twist and tape use wire splices twisting is still a break in the wire hope this helps narrow it down for u

Feb 21, 2013 | Cars & Trucks

1 Answer

1995 yamaha vmax 600 backfires wont start


if it is backfirering sound like timing is out of spects

Feb 16, 2013 | Cars & Trucks

1 Answer

Stop 2min and run for 2min, stop 2min and run for


your motor thermal safety relay is protecting the motor from burning out
this is usually caused by: an old motor about to fail (tight shaft bearings) bad centrifical switch or, an obstruction in the water flow causing the motor to work too hard (draw too many amps, get too hot then cool down and, start up again
check the relay it is located on the side of the motor on most motors; under a cover; unless the motor is bad the relay may just be too sensitive (old) and, may need to be replaced.

Jul 24, 2010 | Whirlpool Jacuzzi Jacuzzi Bath Fuzion EF50...

2 Answers

Why does my 1998 gmc truck backfire and stutter sometimes stall when driving


I would suspect a burnt valve. An engine compression test will verify this.

May 29, 2009 | 2001 GMC Yukon XL

1 Answer

Wont start


you need to have your compression checked. this happened to me and one cylinder was toast. they should be around 120 psi and not more than 5% difference between the two. if not clean the carbs

Jan 31, 2009 | Polaris New Genuine Polaris Snowmobile...

1 Answer

Backfiring


sounds like your timming belt has drirotted out replace then tey again

Dec 09, 2008 | 1991 Honda Accord

1 Answer

Panasonic th50pz700u turns off after about 2min and will not turn back on for 10 to 15? any ideas?


When TV power is off ,Please check how may blinks of power red light ? 7,8,11 of blinks ?
if 7 blinks may Y-UP /Y-DOW or Y-SCAN module problem
If 8 blinks may X-SCAN module problem
if 11 blinks the colle fans problem
from your case .please check 4 fans at back / top of tv case is runing when power tv on ?

Jan 24, 2008 | Panasonic (TH-50PZ700U) Television

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...