Question about Motorcycles

1 Answer

I NEED CIRCUIT DIAGRAM FOR RECTIFIER,TYPE: E108/20 BWruq-Vx

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 99 Answers

Might be easier to find one if you just mention what bike it's off?

Posted on Nov 26, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a circuit diagram of a dewalt charger DE9108-xe 7.2V-18V one hour charger type 1:Q 96307-12/15 OUTPUT : 2.6A 7.2-18.0V 46.8VA


Can you (carefully!) measure the volts across them with a load (battery) and then the current through them by disconnecting one end, and if the charger is still working OK then they are V/I ohms, choose nearest value. 10k sounds very high, are you sure they aren't 1 ohm or less?

May 21, 2014 | Dewalt 7.2-18.0 Volt One Hour Charger

1 Answer

Need wiring diagram to figure trickle charger out


Check the stator for AC output to the charge rectifier, if present stator ok, then check DC on DC side of rectifier if not present change the rectifier, ssuming all fuses have been tested

Nov 08, 2013 | Generac Electrical Supplies

1 Answer

Hello i have a motor cycle orion rx 50 xtreene the problem is that the battery is not charging i measure ac voltage on rectifier from only 4v ac can you help me to sent mee some information about the...


You need to replace the voltage regulator a.k.a. The rectifier. You'll also most likely need a new battery after replacing the rectifier as the cells in the existing battery are probably dead. Good luck!

Sep 16, 2013 | Orion Motorcycles

1 Answer

Where is the bridge rectifier located


They are usually located in the power supply section. You need to refer to the circuit diagram to identify where it is located.

Nov 28, 2012 | Televison & Video

1 Answer

Migatronic 5000mx was welding ok, turned power & wire speed down no longer feed wire fast enough checked and found diode on rectifier blown so replaced rectifier still no wire feed any ideas would be...


Was the rectifier replaced with the same exact device? Or something with comparable ratings and performance? It likely was protecting another active device like an SCR, IGBT, or other type of thyrister which may have failed. If substitutiing a higher rated device for the original, the gate characteristics must match.

Also check some of the heavier resistors as they sometimes do double duty as a fuse in the circuit.

Jan 13, 2012 | Welding Tools

1 Answer

Schematic diagram example of AC DC regulated power supply 1.5volt to 35volt


You will need to add transformer and rectifier diodes before this circuit to be able to get the voltage you need.


See the link below of the regulated part of the circuit

http://simpleelectronic.com/2010/06/11/simple-adjustable-regulated-power-supply-circuit-diagram/

If you need more help let me know.

Sep 29, 2011 | Computers & Internet

1 Answer

I installed a new quality battery,charged it. Dies in one day


It could be either your stator or your rectifier.You should check your AC output from your stator before replacing your rectifier. The rectifier is found bolted to the front side of the battery case.
Here is a link to a diagram to illustrate the location. The rectifier is #24.
http://216.37.204.203/Yamaha_OEM/YamahaMC.asp?Type=13&A=328&B=49

Sep 25, 2009 | 2001 Yamaha YZF-R6

1 Answer

Power Backup


easy one read opt volt rectifier sub with batt may need diode 2 keep batt from rec continus charg shunt dioed hopes this helps sholb be low volt around 9-12v

Mar 28, 2009 | Sony ICF-C111 Clock Radio

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...