Question about Motorcycles

1 Answer

How can i replace front bumper for chana benni

Just remove the top screws

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Hi Ybojang,

The error you mentioned is related to the Microsoft operating system.

Please find the below article for your reference

http://winwiki.org/port-configuration-error-0x000000aa/

Hope it will solve your issue.

BR
Ganesh

Posted on Nov 25, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I replace my chana benni engine for another brand, will it require mods or gearbox replacement?


You need to use the same engine as a replacement or you will run into numerous very expensive problems.

Apr 11, 2016 | Cars & Trucks

1 Answer

How do i replace the front bumper for a chana benni


Consult the factory repair manual. Check with the manufacturer.

Nov 25, 2014 | Cars & Trucks

1 Answer

My chana benni 1300 engin light is coming and flashes it misses and it sound like he is running in three silinders


Write your answer...my chana benni cuts out while I'm driving the I take the fuel cap off the it goes no problem what is wrong with my car

Mar 14, 2014 | Cars & Trucks

1 Answer

How do i adjust a chana benni's headlights


you have two srews one on top for up and down one on the side for side to side dont need much

Oct 28, 2013 | Cars & Trucks

1 Answer

How to replace nissan murano 2011 front driver side turn light


Lift hood, remove grill plastic screws on top, jack car left hand side, remove corner screw on end of bumper, undo lower splash shield screws, slide bumper away from car {about 4 inches}, remove,top bolts on headlight and lift out, the is a locating slot that you will need to manipulate it from, assembly is the reversal. good luck.

Oct 20, 2013 | 2007 Nissan Murano SE

2 Answers

I need to replace the front left turn signal on a 2004 ford escape. How??


Open the hood . Looking at the headlight assembly.Directly behind it there are 2 clips in the frame. you will have to pull these up and out. Then the assembly will pull out from the from to access the sockets and bulbs. the sockets turn to get them out. sometimes the is another clip that will hold the assembly in. just pull on the assembly and it will pop loose.

Jul 08, 2011 | 2004 Ford Escape

1 Answer

Jaguar x type 2004 front bumper


Front bumper removal is quite easy. To start with there is 4 10mm bolts one by each headlamp ( with the bonnet open) remov them. There is 3 T30 screws that hold the under tray to the subframe and there is also a small corner trim that is on the bumper side of the front wheel arch here is 3 T30 screws holding them on on each side. Finally remove the front wheel arch lining so you can get acsess to the inside of the bumper. You will then see a 10mm bolt towards the top of the bumper that is reversed to you. Remove then the bumper should then just pull away.

Becareful not to damage the fog lamp harness upon removal

Apr 08, 2010 | 2004 Jaguar X-Type

1 Answer

How do i replace the headlights


Front bumper requires removal to gain acsess to the lower 10mm bolts. Bumper comes off by removing the 2 10mm bolts on the top of the bumper then unscrew the 2 T30 screws in the front wheel arch liner (bumper side) and then you will be able to see a 10mm bolt reversed into a bracket at the top of the bumper from a inside veiw, remove and repeat for the other side. Then its 3 10mm bolts that secure the front under tray (if yours has one). Then there will be another 10mm bolt to the wing side of the headlamp from a above veiw. Bumper should then just pull off and watch for the connector for the fog lamp harness.

Just the 2 lower headlamp bolts andit should pull from its housing

Mar 29, 2010 | 2003 Jaguar S-Type

1 Answer

How you take off the front bumber


have 96, 95 similar

Section 01-19: Bumpers 1996 Villager Workshop Manual
REMOVAL AND INSTALLATION Bumper and Bumper Cover Front
Removal
  1. Raise and support the vehicle.
  1. Remove the RH and LH front wheel (1007).
  1. Remove the RH and LH front fender splash shield screws. Remove the RH and LH front fender splash shields (16102).




  1. Remove the four front fender brace screws.




  1. Remove the two front fender brace nuts.
  1. Remove the two plastic screws.
  1. Remove the seven clip buttons located under the front bumper cover (17D957).




  1. Remove the RH and LH front turn signal lamps (13369). Refer to Section 17-01 for the removal procedure.
  1. Remove the four front bumper cover brace bolts.




  1. Remove the front bumper cover from the vehicle.




  1. Remove the two front turn signal lamp wire harnesses from the front bumper (17757).



  2. Remove the eight front bumper bolts.




  1. Remove the front bumper from the vehicle.

Mar 02, 2010 | 1995 Mercury Villager

1 Answer

I would like to remove the front bumper of my 2003 Civic Hybrid. I want to replace the horn which is under the bumper.


pop hood .... remove clips directly on top of the bumper.... remove screws in fender.... and bolts under the bumper.... thats what i did on my civic yours should be similar.....

Jun 17, 2009 | Honda Civic Cars & Trucks

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...