Question about 2005 Suzuki Boulevard C90

1 Answer

<!-- from fixya rte -->Where is the coolant resevoir located - 2005 Suzuki Boulevard C90

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 157 Answers

A C90 is not a water cooled engine. It is a design that uses air and oil to cool the engine. There is no conventional radiator or coolant on this model. The finned cooler you see on the front of the bike is an oil cooler.

Posted on Nov 15, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where does the overflow hose drain out.....the location

The overflow drains and picks up coolant from the overflow bottle, or coolant resevoir. This is the same bottle where you top off your antifreeze. Usually located near the radiator.

Sep 04, 2011 | 1995 Chrysler Cirrus

2 Answers

Where is the battery located at?

The battery is located under the rear passenger seat. The entire seat comes off.

Jan 03, 2011 | 1996 Oldsmobile Aurora

1 Answer

The coolant light remains on even after the radiator has been replace

have you checked the plug in at the coolant resevoir? if good, have you checked the fuse panel for blown fuses? low coolant light comes on because the sensor n the coolant resevoir tells the computer says there is not enough fluid in your resevior, the clear tank under the hood that connects to the radiator. you may have a bad plug in or a bad resevoir. i suggest you check fluid,,if good ,,check plug in,, if good,,replace resevoir,, hope this helps!!

Sep 19, 2010 | Oldsmobile Intrigue Cars & Trucks

2 Answers

Engine coolant light turns on but no aparant reasons why engine coolant level ok rad was flushed 2 months ago coolant temp gauge doesnt go past half way hot and cold air availabe in the cab

the coolant level sensor is malfunctioning. this should be either on the resevoir or screwed into the side of the radiator. inspect to see if there is one in the resevoir. if so, disconnect it and turn the vehicle on to see if the light goes out. if so replace it. if it is in the radiator, replace it. ther eare no "fixes" for these items.

Jan 25, 2010 | 1996 Saturn SL

1 Answer

How do I bleed the air out of the coolant on a 2000 Monte Carlo LS 3.4L?

Look for a bleeder screw at the highest point of the coolant system, it is usually located on the thermostat housing. Once located open screw with engine off and cool, and pour coolant into the coolant resevoir/ radiator until steady stream of coolant starts to come out of bleeder screw.

Nov 24, 2009 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Owners man. does not locate the power steering resevoir, I believe it is on the pass. side in front of the coolant resevoir is that correct?

think its electric pump type and its at the back low down passenger side LHD ,pain to check level let alone top up

Nov 20, 2009 | 2000 Volkswagen Jetta TDI

1 Answer

I have a 2000 Expedition and I believe I have a coolant leak and I can see that all the coolant that I add to the coolant plastic tank trickles down over transmission housing next to the oil pan. What...

Don't overfill the coolant resevoir when adding coolant. There is a cold and hot fill line on the resevoir. Excess coolant will spill out through overflow tube on resevoir.

Sep 08, 2009 | 2000 Ford Expedition

1 Answer

Radiator light stays on

yes but is the coolant resevoir the sensor is located in the resevoir, if full then the resevoir needs to be replaced.

Aug 29, 2009 | 2000 Ford Focus

1 Answer

Low Coolant light stays on

Check you coolant resevoir. The low coolant switch is located in the resevoir so if it is low on coolant there, the light will come on. If it is full, it could be that the switch is stuck due to gunk build up in the resevoir. Hope this helps you out

Jan 19, 2009 | 1993 Chevrolet Beretta

Not finding what you are looking for?
2005 Suzuki Boulevard C90 Logo

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

75807 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides