Question about Rieju Motorcycles

1 Answer

How do i check oil on rieju marathon 450

Where do i check oil level

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 34 Answers

Should be a dipstick up in front of the fuel
tank. These have oil in the frame and use
a dry sump oiling system. Run it for
a few minutes then check. Only holds about
1 litre of oil total so don't overfill.
It will only show oil on the dipstick after
running a bit as the oil needs to be pumped around
the system to be accurate on dipstick reading.
--

Posted on Nov 26, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 653 Answers

SOURCE: 07 rmz 450 fork oil lvel

about 200-250cc in each fork. Good?

Posted on Apr 26, 2010

Motoxpartson
  • 185 Answers

SOURCE: How to check the oil

OK to check oil level you have a little dip stick on the left hand side on the frame of bike just in front of the fuel tank to check this dip stick you need to start the bike and idle only (not rev up or ride) and you idle the motor for 2-3 minutes with the bike in upright position. then turn off motor keep in up right position and remove dip stick - wipe the stick clean then insert dip stick back in its hole (without screwing in) then remove it to see oil levels.
a good quality 20w-40 weight oil (motor bike specific) is a good choice but pretty much any decent oil from your motorcycle shop would be OK just discuss it with them when you purchase it I not sure what country you from but where I live our Yamaha shops sell Yamalube and this is perfect a bit pricey but for our favourate toy, it is worth it!
To fill the oil there is another plug on left hand side again at the front end of the motor you will see it is the only plug there that can be opened with fingers - you will need a funnel to fill cleanly as is pretty difficult to pour into it with out spilling otherwise?
Your bike holds only 1.2 liters (1200ml) of oil in total so if you not changing oil filter and completely emptying then oil lines, only add up to 1 liter for a simple oil dump and refill.
Hint for the day with oil is - On a MX bike the more often you replace the oil the longer it will last before needing repair I would always recommend changing oil either once a month or every 3 hours of riding use which ever comes first !
I am often told I am over cautious with this oil change strategy but I also have YZ450f 05 and a 2003 model and I have never had to rebuild because of break down or fault with motor
Maybe this is coincidental ? but then again - Maybe not ??
good luck hope this helps a little
regards Jamie

Posted on Jul 02, 2011

  • 1702 Answers

SOURCE: Were do you check oil level on yzf 450 2005 mod

Hi, If it is a 2 stroke engine you will not need to check oil level. Because the oil is in the mix already. If it is a 4 stroke there will be a black or gray screw type plug on the crankcase. It will also have a dip stick on it. Good luck.

Posted on Aug 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1995 Yamaha SRX 400 Monoshock - How do you check the engine oil level. I.E. with the bike level or leaning over on its side stand?


Hi, Miketecham with the bike level engine oil hot for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.srx600.net/srx400/3vnengine.php&heading=SRX400(3VN)%20Info
http://www.apriliaforum.com/forums/showthread.php?82247-Checking-The-Oil-Level
How to check the Oil Level in your Motorcycle
Yamaha SR500 SR400 Forum
Yamaha SRX440 1980 Service Manual

Aug 11, 2016 | Yamaha Motorcycles

1 Answer

Buick riviera 1995 check oil level comes on


the oil level sensor in the oil pan is probably going bad.

Feb 03, 2012 | 1995 Buick Riviera

1 Answer

Just bought a 2006 Crossfire. The area where the (Trip Milage) is, a beep then the Oil Logo with the word HI comes on once a day at least. The Manual says the Oil has too much and the oil pan needs to be...


Yes its mentioned correct in manual.The HI indication comes on when there is about 1 quart too much oil. Get the excess oil drained.----------- CHECKING ENGINE OIL LEVEL:-------- A sensor in the oil pan allows oil level to be checked
without opening the hood. It provides an accurate measurement of oil level, whereas the low engine oil level indicator warns that oil level is definitely too low. With the vehicle parked on a level surface, the engine is warmed up and shut off for approximately five minutes.When the ignition switch is turned to the ON/RUN position, an ISO oil level icon appears in the trip odometer window and a "clock" icon in the cumulative odometer display. Pressing the knob to the left of the speedometer twice within one second displays one of the following messages:
• OK
• -1.0 Q (-1.0L)
• -1.5 Q (-1.5L)
• -2.0 Q (-2.0L)
• HI
The indicated amount of oil must be added to the engine
if the message -2.0 Q (-2.0L) blinks and a signal sounds.
The HI message indicates that the excess oil must be
removed from the pan to avoid possible engine or
catalytic converter damage. If the ISO oil level icon and
"clock" icon remain on when attempting to check oil
level and no message follows, or if the low engine oil
level warning lamp comes on, a malfunction in the
engine oil level system is indicated. A conveniently
located dipstick allows manual checking of the oil level.
If no leaks are noted, continue to drive to the nearest
service station where the engine oil should be topped to
the "full" mark on the dipstick with an approved oil.--------------------

Apr 09, 2011 | Chrysler Crossfire Cars & Trucks

1 Answer

I want to check the engine oil level for previa 2.4 petrol 1995



OIL LEVEL CHECK Every time you stop for fuel, check the engine oil as follows:
  1. Park the vehicle on level ground.
  2. When checking the oil level it is best for the engine to be at operating temperature, although checking the oil immediately after a stopping will lead to a false reading. Wait a few minutes after turning off the engine to allow the oil to drain back into the crankcase.
  3. Open the hood and inspect the level of the engine oil tank. The fluid level on the tank should read between FULL or F and LOW or L.
  4. If the level is below the LOW or L line, remove the cap and add enough engine oil to reach the FULL or F line. Fig. 1: Fill the engine oil tank located under the hood first 90911p07.jpg
  5. Install the oil cap and hand tighten.
  6. After filling the oil tank, remove the engine access hole cover on the drivers side. Fig. 2: Make sure the oil tank is to the F mark 90911p15.jpg Fig. 3: The oil dipstick is located under the driver's side engine access hole cover 90911p83.jpg Fig. 4: Place your finger through the hole and pull straight up to remove 90911p84.jpg
  7. Remove the engine oil dipstick and wipe it clean.
  8. Reinsert the dipstick, push it in as far as it will go, the pull it out and look at the level on the end.
  9. If necessary, insert more oil through the oil filler cap next to the dipstick, this will completely top off the system. Fig. 5: The oil dipstick has two markings for level check 90911p85.jpg Fig. 6: To fill the crankcase, remove the engine oil filler cap 90911p86.jpg prev.gif next.gif

Nov 06, 2010 | Toyota Previa Cars & Trucks

1 Answer

Where is the transmission dipstick in my manual 1.3 liter 1993 suzuki swift located and where do i fill it up?


LEVEL CHECK With Oil Level Gauge Fig. 1: Manual transaxle oil level check - with level gauge 84241046.gif
  1. Drive the vehicle to bring the transmission up to operating temperature.
  2. With the engine stopped, remove the oil level gauge front the side case of the transaxle.
  3. Check the color and smell of the oil. If it is black in color or smells burnt, further transmission service is needed.
  4. Wipe off oil level gauge with clean cloth.
  5. Fit the oil level gauge to the transaxle side case so that the threads rest on top of the case.
  6. Remove the gauge and check oil level. The level should be between FULL and LOW level line.
  7. If the level is below LOW mark, add oil until the proper level is reached.
With Oil Level/Filler Plug
  1. Drive the vehicle to bring the transmission up to operating temperature.
  2. Raise and support the vehicle safely.
  3. Remove the transaxle oil level/filler plug.
  4. Check the color and smell of the oil. If it is black in color or smells burnt, further transmission service is needed.
  5. Transaxle oil level should be even with the bottom of the plug hole. If oil level is low, adjust oil level accordingly.
  6. Install transaxle oil level/filler plug and tighten to 40 ft. lbs. (54 Nm).
  7. Lower the vehicle.

Oct 17, 2010 | 1993 Suzuki Swift

1 Answer

Where do you check engine oil? Should there be a


hi,
you can check the oil level in your bike by using the "oil sight glass" at the lower part of engine in the left hand side of your bike, just below the left foot peg.there are two marks, the upper mark referring the maximum capacity for oil level and the lower mark showing the minimum level.The oil level can be anywhere between these two marks.Please make sure of two things while you check the oil level in your bike.
  • Run your engine for two min so that the oil is warm while you check the level.Never check the oil level in a cold engine.
  • Hold the bike in upright vertical position while checking the oil level.
I have provided an example picture showing the location of the oil filter in a Yamaha v-star.Hope your problem is solved.Please rate my solution as 8a0e22a.jpghelpful.Have a great day.

Mar 08, 2010 | 2001 Yamaha V Star 1100 Classic

2 Answers

Oil light on


first make sure oil level is up, then check or just replace oil preasure switch, if light still comes on, have your oil preasure tested, could be low oil preasure or electrical problem start there. good luck.

Oct 29, 2009 | 1998 Dodge Intrepid

1 Answer

Transmission fluid level check


The owner of the car should be able to check the oil fluid and coolant levels .get a clean peace of cloth.tools for removing trans axle /differential filing plugs. so that when the oil or fluid and coolant levels are checked they must be on desired levels.Locate the oil metering rod or dipstick and measure the lubricating oil level. Remove the transmission filler plug and check oil level. Remove differential oil filler plug and check oil level .Check fluid level .check coolant level.Observe all safety rules .Use the correct preventive maintenance procedures. If the owner can't do it then it is suggested that he should go to a car mechanic and the mechanic will do the job.

Oct 01, 2009 | 1999 Daewoo Lanos

1 Answer

Need to know how to check oil in transmition in a 95 ford aspire


Check the engine oil level every time you fill the gas tank. The car should be on level ground when checking the oil.
  1. Turn the car off and wait several minutes.
  2. Locate the engine oil dipstick and withdraw it from the tube.
  3. Wipe the dipstick with a clean rag and reinsert it in the dipstick tube.
  4. Remove the dipstick again, hold the dipstick horizontally and observe the level of the oil.

5794dd4.gif
Fig. 1: Grasp the engine oil dipstick and withdraw it from the tube

22d3954.gif
Fig. 2: Observe the oil level on the dipstick and add oil if it is low

  1. The oil level should be at the FULL mark on the dipstick.
  2. If the level is at or near the LOW mark, replace the dipstick and add fresh oil to bring the level up to the FULL mark. Do not overfill.
  3. Recheck the oil level and close the hood.

Good luck, and remember rated this help!!!





Aug 18, 2009 | 1995 Ford Aspire

1 Answer

How to cheack the oil


there is a oil level window on the side of the motor when checking level have motorcycle upright and level you should have a low level line and a full line! pretty much any motorcycle grade oil avoid car oil it's not designed to work in a wet clutch enviroment also remember when changing the oil upright check level and top off oil after running engine 2 to 3 minutes (you have to fill the oil filter) wait 2 to 3 min. before checking level!

Jun 22, 2009 | 1990 Yamaha FZR 1000

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rieju Experts

Steve P
Steve P

Level 3 Expert

3425 Answers

Cole Palmer
Cole Palmer

Level 1 Expert

9 Answers

Gregg Mahin
Gregg Mahin

Level 3 Expert

41912 Answers

Are you a Rieju Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...