Question about 2012 Suzuki RM-Z 250

1 Answer

My 2010 rmz stalls down hills , I have to be ******* back brake and rev throttle all the way down hills? and if I come to a stop with clutch in and hold clutch in it also stalls unless revving the thr

It is the 2010 model not letting me select 2010 not sure why any help would be great

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 603 Answers

It sounds like you have a problem with fuel starvation. Check from fuel tank to carburetor. Tank may have sludge in it, shut off valve may have clog or rust, fuel lines when old tend to collapse in on them selves, filters clog or become dirty, and carburetors tend to accumulate dirt, water, clogs, and may need to be rebuilt. Since you are running fairly well, your problem may be small and inexpensive. GOOD LUCK FRIEND.

Posted on Nov 08, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 13 Answers

SOURCE: '03 gsxr 600, rusty fuel tank n rough revving

carbs need a good cleaning. had this same problem with an 82 GS1100. cleaned the tank as best i could, you can never get all the rust tho. finally had an idea to place a couple of old car speaker magnets on the outside bottom of the tank to catch any residual rust. been 4 years now with no more problem.

Posted on Apr 14, 2009

  • 14 Answers

SOURCE: Drives great but at/when drops to idle it stalls

When you are on the bike and riding do you still have the choke out? And stop spraying starter fluid into the carbs..bad bad bad.... bikes start with out that stuff and if you need it then something is wrong.. your gonna mess something up doing that....let me know about the choke and we will go from there...cj_monaco@hotmail.com

Posted on Jun 21, 2009

  • 12 Answers

SOURCE: rmz 250 04 model wont idal or kick start

Like I told somebody earlier to day lower the octane rating of the gas you are using....repost if you need anything futher......

Posted on Jun 22, 2009

nedkelly900
  • 345 Answers

SOURCE: My 03 RM250 runs great under A load but when he

This is normal for a two stroke, and nothing to be concerned about. The engine will do this with no load and full throttle, a bit like a govener cutting in. It only becomes a problem if it does it while riding.

Posted on Jun 25, 2010

  • 3567 Answers

SOURCE: 1980 suzuki gs850 ... sometimes

Check the compression on each cylinder. Chances are good the bike needs a valve job.

Posted on Mar 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my Yamaha grizzly 700 engine brake fail going down hill


If you're in to low a gear, the clutch might be slipping under stress from high revs. You might need a new clutch or stronger springs. Try using a higher gear and use 50% braking.

Jun 21, 2014 | Yamaha 2007 Grizzly 700 FI 4x4 Auto...

1 Answer

My 2010 rmz 450 crackles and pops at low revs, and surging when cruising, also backfires when i shut of the throttle, i have fitted a wiseco fuel mangement unit and played around with it but no luck,


sounds like a few things, bad/fouled spark plug,old/clogged fuel filter/old air filter or bad fuel. When taking bikes out of storage bikes often suffer from this problem from old fuel sitting in bike gumming it up.

May 21, 2014 | 2010 Suzuki RMZ 450

1 Answer

Hi I have a 2002 Corolla with an apexi, when driving it can start to splutter a bit and I have to put my accelerator down fully just to maintain the revs, then as the car slows I have to change down a gear...


Most common problem is the IAC(Idle Air Control) valve.But if you say some times work I will suspect the throttle is clogged. Remove the Air hose,apply full throttle and hold, spray carburetor cleaner on clot using thin long nose player clean inside wall and throttle. don't spray directly inside because the carb cleaner is to aggressive for some of the gasket.
Good Luck

Apr 03, 2014 | Toyota Corolla Cars & Trucks

1 Answer

1991 Suzuki Swift GTi very low idle and stalling


Oxigen sensor. Check accelerator pot also, and fuel pump.

Jan 13, 2013 | 1991 Suzuki Swift

1 Answer

Car stalls after warm on hot day after a few stops. will stall when stopping at intersections, and when taking foot off the gas going down hills.


The idling setting in the car is not set correctly or the idling is LOW due to fault in the setting.
You will need to check if the throttle position is correct and the idle setting WITH THE CLUTCH PRESSED must be of the CORRECT IDLING RPM. If not reset the position after cleaning the system.

Aug 09, 2011 | 2002 Ford Taurus

1 Answer

Problem is in top rev range is braking down and backfiring this is a 2010 rmz 450


You need to most likely have the TPS checked (set at full throttle not running 4.85 volts) and or CDI remaped at dealer

Aug 17, 2010 | Suzuki RM-Z 450 Motorcycles

1 Answer

Idles rough when coasting


Have you checked all the vacuum pipes around the top of the engine.?
It`s not losing oil pressure, it`s just about to stall when the oil light comes on.
Listen for a hissing noise under the hood.
Vacuum leaks can cause real problems with the inlet manifold pressures.
Good luck.

Jan 31, 2009 | 2000 Pontiac Firebird

2 Answers

Stalls out when braking quickly, worse with going down hill


Assuming that the vehicle is equipped with an automatic transmission, it looks like the torque converter lock-up system doesn't release as fast as it should, so if you brake hard, the converter is still locked up and your wheel brakes stall your engine (just like pressing ******* the brakes with the clutch pedal released on a manual transmission vehicle). Normally, when you brake hard, the lock-up should release and prevent the stall from happening. Might be a bad torque converter, or a bad lock up solenoid in the transmission... Before jumping to anything else, i'd try checking the fluid level in the transmission and an oil/filter change in the transmission. Lots of times one or the other can cure the problem.

Jan 13, 2009 | 1995 Nissan Pathfinder

3 Answers

Jeep stalls



I had the same problem... frustrating.

I picked up a repair manual at the parts store. I took off the throttle body and cleaned it with throttle body cleaner spray. I changed the Idle Air Control Valve (idle speed motor) which was very clogged. While I had the throttle body off I also changed the Map Sensor and Throttle Position Sensor. The manual will walk you through the steps. I had never done anything like this before. If I can do you so can you.
My Jeep has never run better. Good Luck

Sep 26, 2008 | 1991 Jeep Comanche

1 Answer

Clutch won't engage and back wheels locked


sound like back brakes locked up burn up your clutch.

Jul 28, 2008 | 1996 Ford Aspire

Not finding what you are looking for?
2012 Suzuki RM-Z 250 Logo

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...