1997 Cadillac DeVille Logo
A
Anonymous Posted on Sep 29, 2014

How do i fix or solve this problem with my oil pressure light showing this malfunction and what could be the problem

1 Answer

steve h woody

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Cadillac Master 2,551 Answers
  • Posted on Oct 01, 2014
steve h woody
Cadillac Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: May 06, 2008
Answers
2551
Questions
10
Helped
504337
Points
10228

If you have the north star motor could be oil pump or sending unit for oil gauge start with oil pressure sending unit the little hole in end of sending unit get clogs and or just give up

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer
0helpful
1answer

Engine malfunction light came on with low oil pressure when i started car. engine light stayed on. do i just need an oil change

you need to have the oil pressure checked by using a mechanical oil pressure gauge
that will determine if it is a pump problem or an oil gauge sender unit
changing the oil will not fix the problem
you should be doing oil and filter changes every 10,000 miles and then that oil change suggestion would not figure in the problem
your problem is either mechanical or electrical but you need to determine which before you damage the engine
1helpful
1answer

I have a 2005 Mercury Sable, it shows the oil is full on the dipstick but the low oil pressure light has come on twice, what could it be?

Low oil pressure has little to do with oil level. The best is to take it to a service agent to have the oil pressure checked. It is very possible that you have a faulty pressure switch, and just changing the switch will solve the problem, but if you have an oil pump problem, causing low pressure, you have a major problem. Have it checked.
1helpful
1answer

What can i fix on my 2003 buick lesabre to prevent it from shuting off in the middle of driving,and my check oil light is on even when i put oil in it

If you find the problem with the light, it may solve your shutting off problem. Does it show the oil pressure on a digital read out? If so, is it reading 0? I would start by changing the oil pressure sensor. I have done two of these on the same car(it is a common problem). If that doesn't fix it, at least you have eliminated that possible problem.
0helpful
2answers

Oil pressure warning on 2001 Volvo v70 with 220Km

2 things i would do professionally first. 1. change the oil using a higher weight and a volvo oil filter(there is a difference) 2. have a "wet" gauge installed at the oil pressure sending unit to verify oil pressure from cold to warm. a "wet" gauge is a gauge that reads actuall oil pressure and not the use of electronics. it is usually very acurate. if the oilp pressure still drops, then you are looking at an oil pump issue most likely.
12helpful
1answer

My 01 bonneville oil pressure gauge is showing 120 and my gas gauge is all over the place

HI, the oil pressure sending unit may be malfunctioning at this point. this will cause erratic readings. if your oil level is proper and there are no apparent oil leaks, you will need to replace the oil pressure sending unit. this will fix the erratic oil pressure readings.

Concerning the gas gauge. this device also has a sending unit that sends the correct fuel level reading to the gas gauge via wire transfer. this sending unit is located and attached to the fuel pump assembly inside the gas tank. replacing this device will fix this issue as well.

Please rate and god bless:)
4helpful
2answers

High oil pressure reading

Oil sending unit bad. Replace.
0helpful
1answer

Oil pressure light

Oils in long over due service forms **** which can't be circulated properly under normal oil pump pressure causing Crank shaft or cam shaft bearing recieve the lubricant quite late. The said bearings could be damaged.

For the light, the oil pressure switch could have accummulated some **** which is making it malfunction.
Not finding what you are looking for?

80 views

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...