Where is the clutch valve located on a 95 honda accord

Yes they are but the stacking of them in the drum is different.

The switch is located on the foot brake lever. there is a pin to pop off, then pull the switch off and disconnect the plug fairly easy to do

u have to take off tthe valve cover and pull out old tube seals that are in the valve cover and replace them with new ones and a new valve cove r gasket

Did you replace the fan? How about the fan switch?

Here is some stuff to read about this system....please let me know what's up!


This switch is the primary controller of the operation of the radiator fan(s) used for cooling. When the coolant in the system reaches a pre-determined temperature, the fan switch closes and completes a circuit. The fans will be brought on. Generally, the switch communicates with the fan relay, although the later PGM-FI cars send the signal through one of the many solid-state controllers first. Do not assume that the switch is the only component in the radiator fan circuit which controls its operation. There are many other components whose failure may prevent the radiator fan from operating. If the fans are not working when the engine is very warm, check the fuses first.
On all vehicles except 1990-95 Accords and 1992-95 Preludes, the fan switch is located in the bottom of the radiator. On 1990-95 Accords (except V-6) and 1992-95 Preludes, the switch is located in the housing at the rear end of the coolant connecting pipe. This is the pipe running along the outside of the engine, just above the oil filter. The switch the only electrical component in the housing. On the Accord V-6, it threaded into the side of the coolant crossover pipe (not next to the bleed bolt) on the transaxle side of the engine.

it could be your downshifting at the wrong RPM ensure it is correct can blow a seal if thats not it check the fly wheel could be missing teeth

yes it think that would do it to

try these websites fix & troubleshoot heating & A/C www.automedia.com and another one is car A/C repair www.directgardening

May be a bad pressure plate, because if it was the clutch hydraulics the pedal will go to the floor. Good Luck

follow the top radiator hose. that hose leads the the therostat housing

The idle air control valve should be located directly behind and a little bit below the Fuel rail that supplies the injectors depending on the date of manufacture. If it is not located there, look straight off the passenger end of the fuel rail. In any case it should be locate immediately after and in the fuel path after the unused fuel leaves the fuel rail to return to the tank.