<!-- from fixya rte -->Engine trouble warning light - 2007 Yamaha TMax

ave vehicle scanned for trouble code --test for overheating --your vehicle is going into limp/shut down mode to save itself

Just like every other warning light on your vehicle, when a warning light is on, a trouble code is stored in the computer to tell you where to begin your diagnosis. Get the trouble code read.

http://ricksfreeautorepairadvice.com/check-engine-light-on-part-i/

An airbag warning light is no different than an engine warning light--you have to get the trouble codes read to find out where to start.
Check engine light on Part Ricks Free Auto Repair Advice

In most vehicle, Transmission warning light incorporated in Check Engine light (ie, when you pull check engine light codes, transmission trouble code will be among it, if there were any), other case, its in your PRNDL indicator light (ie. PRNDL light will blink when transmission has problem), and in another case, you need to have a special scaner that capable of pulling transmission trouble code. I hope it helps :)

Yes I would say the oil pressure switch is faulty. The oil pressure gauge uses a different sensor, so if the gauge did not drop but the warning light came on, I would have the warning light switch checked. If the warning light comes on, the fuel pump will stop getting power and you will lose fuel pressure too.

When the warning light is on, you should take the Jeep somewhere to get the computer scanned for trouble codes.

That's an engine warning light. The other is a tyre pressure warning light.
You will need an OBD2 scanner to read any engine trouble codes.

Engine management warning light on ?????? What DTC'S - diagnostic trouble code's stored in the PCM - engine computer ? Should have DTC'S stored

Most likely a wheel speed sensor, hopefully... The only thing that will change when the ABS light is on is that the ABS will not function as long as the indicator is on. I hope this info helps.

When the airbag system is in functioning condition, the airbag warning light will remain on for about 7 seconds and go out when the ignition switch is set to ON .

If there is any malfunction, the airbag warning light will either stay on or off continuously. In such cases, perform on-board diagnostic in accordance with the specified procedure to determine trouble codes.

1. Turn ignition switch ON (with engine OFF ).

1. Connect DIAG. terminal to No.2 terminal of diagnosis connector located inside lower cover.
2. Check in accordance with the trouble code indicated by the AIRBAG warning light, and record the trouble codes.
3. Turn the ignition switch "OFF " and remove the DIAG. terminal from No.2 terminal of diagnosis connector.

HOW TO READ TROUBLE CODES
The ABS lamp flashes a code corresponding to the faulty parts.

The long segment (1.2 secs on) indicates a "ten", and the short segment (0.3 secs on) indicates a "one".





NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.




CLEAR MEMORY
After eliminating problem as per trouble code, clear memory as follows:

Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal (1) on diagnosis connector (2) terminal No.1.

where warning light is flashing, connect the other DIAG. terminal (3) on terminal No. 2 for at least three seconds . After memory is cleared, normal warning light flashing rate resumes. (Warning light flashes every 0.6 seconds (ON-OFF operation.) Memory cannot be cleared if any problem exists.

After clear memory and then DIAG. terminals (1) and (3), extract from diagnosis connector (2)

you need to have the trouble codes checked with a obd2 code reader.
it could be the throttle postion sensor if the car would not accelerate but there is no way to tell for sure until you see what trouble code the vehicle is throwing. most auto parts stores will check them for free. hope this helps