Question about 1989 Honda CBR 600 F Hurricane

1 Answer

1989 cbr 600f Holland EU, Eric my gashandel does not run smooth it jumps when i give gas after i come out of a corner I already put oil on the cable but that is not working enough

Posted by on

  • steve t May 11, 2010

    sounds like your cables are run to tight against the frame....try this..just start the bike and move the handle bars slowly from side to side if the rpms increase even a little thats probably the problem... if not its the throttle grip assembly...its a dual cable push pull system!



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Ive had mine give me some issues, try these:

proper tension on throttle cables, there should be two, also make sure the rod the cables is pulling is lubricated, having clean carbs externally is just as important as internally,

Posted on Sep 30, 2009


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer


you have be carefull

Posted on Mar 25, 2009

ollie reece
  • 1167 Answers

SOURCE: Hey, 93 CBR 600F where's the air box

hi budy there below the tank you need to unscrew the tank bolts by steering and take seat off then the tank will tilt up

Posted on Sep 09, 2009

Testimonial: "Cheers mate worked "

  • 224 Answers

SOURCE: cant remove seat from cbr 600f

after you remove the 2 side tail pieces, there are 2 bolts (one on each side) that hold the seat in place. on my 1998 cbr600f3 it's 2 12mm bolts.

Posted on Jan 12, 2010

  • 2418 Answers

SOURCE: where can I get hold of a set of body work for my

-> <-
Check out this site for your fairing needs.

Posted on Feb 07, 2010

  • 518 Answers

SOURCE: how do i replace a air filter on my honda cbr 600f

it depends on the diameter of the carb inlet,the space between the carb and frame ,will the new filter fitting match up to the carb dia,

Posted on Jul 03, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the starter motor on my cbr 600f 1989

Try the following link to download a full service manual for free.
You will find it the starter motor by removing your fuel tank and left engine hanger plate. This is described in section 17, page 4.

Jul 10, 2014 | 1997 Honda CBR 600 F(3)V

1 Answer

Where are the fuses on cbr 600f 1989?

Left side fairing panel under the handlebars.
its probably a stuck solenoid,under the rhs seat panel.
or bad connection to the starter

Jul 10, 2014 | 1995 Honda CBR 600 F(3)S

1 Answer

CBR 600F cuts out when given throttle

Hi, Anonymous and the usual suspects are:
1. Idle port, transfer ports, slow air jet clogged.
2. Idle adjusting screw set too low.
3. Air fuel mixture adjustment too lean.
4. Pilot/slow fuel jet clogged.
5. Faulty accelerator pump.
6. Float level too low.
7. Float bowl contaminated old fuel, water, dirt, rust, etc.
8. Carburetor bowl vent line clogged/blocked/pinched.
9. Fuel line to carburetor kinked or pinched.
10. Fuel filter clogged.
11. Intake manifold leak.
12. The gas cap is not venting properly or fuel tank venting system blocked.
13. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
14. Needle and seat stuck closed in the float bowl.
15. Multi carburetors not in sync.
16. Faulty fuel pump.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Bike idling with choke on dies when applying throttle CBR Forum Enthusiast...
cbr600f cutting out
Honda CBF600SA Service Manual
Honda CB Owners Manuals

Oct 14, 2017 | 1989 Honda CBR 600 F Hurricane

1 Answer

What kind of maintenance should i do to my 1989 cbr 600 f to keep it in tip top running condition

  • Change gearbox oil every 3000 miles. Change oil filter every 6000 miles. Use 10w40 motor oil. NEVER use synthetic lubricants as they can mess up the clutch.
  • Oil the chain every two weeks. Lube the control cables every oil filter change.
  • Keep the gas tank full in the cold months. This lessens internal tank rusting due to condensation in the tank. Drain the carbs when the bike will sit over the winter unless you plan on starting the bike every two weeks and letting it run for 15 minutes each time.
  • Be sure the gas valve is turned off when the bike is not in use.
  • Get a 2 amp trickle charger and charge the battery once a week for 4 hours in the winter. Be sure to keep enough water in the battery to cover the top of the plates in each cell. Know that batteries only last two years or so.
  • Check the chain tension once a month during the summer riding season.
  • Please rate my answer. Thanks.

Sep 11, 2010 | 1989 Honda CBR 600 F Hurricane

2 Answers

How much fork oil do i put in a cbr 600f 1990

Between 275 to 325cc but left and right will differ in amount by 25-35cc. Too much will make the rebound harfer, too little will easily and quickly destroy the fork seals.

Aug 31, 2010 | Honda CBR 600 F(1)L Motorcycles

1 Answer

Where can I get hold of a set of body work for my 1989 cbr 600f haineuric

-> <-
Check out this site for your fairing needs.

Feb 07, 2010 | 1989 Honda CBR 600 F Hurricane

1 Answer

2000 cbr 600f cutting out after 2-3 mile

buddy i had this problem once and i found the float was bent one side was lower than the over have a look if its not lower the float a tad by bending the metal the little needlt valve is on

Aug 22, 2009 | 2000 Honda CBR 600 F(4)Y

1 Answer

The powervalve will not work

guten tag -you need to buy a manual in a bookstore there are many authors easy to read ones also make sure itz mechanical and not electrical or carburation-or find someone in phone book that experience and is cheap

Jul 30, 2009 | Honda CR 125 R Motorcycles

Not finding what you are looking for?
1989 Honda CBR 600 F Hurricane Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4904 Answers


Level 3 Expert

79865 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides