Question about 2001 MZ 125 SM

1 Answer

I wish to up grade my bike to it more powerful..how can i do that?where can i get the performance part for it?im riding mz125 sm and im in malaysia

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

If you are serious about more HP then get a race cam for the bike. Hold tight to the handlebars. Contact Web Cam Racing (1-951-369-5144) in California and they can fix you up. I estimate $300us. Add and shipping both ways. The web address is www.webcamshafts.com You would ship your cam to them by Federal Express and they would modify the cam to your specifications then send it back. Neither you or I can give them degree angles for rise or duration or any other spec they may need, so you just need to tell them what type of racing you do (street, track, quarter mile etc ), and what you want from the cam, take off from the line, top end speed, torque, etc.. Basically, tell them you just want to wax anyone dumb enough to challenge you street.

Don't get too radical with the cam. Go too far and the bike will only start with a car pulling you at 30 mph. I am serious. Tell them you want to start the engine using the kick starter. Also tell them any modifications you have made > air cleaner, sprockets, tires, exhaust etc.. ASK FOR THEIR RECOMMENDATIONS on the above and on ignition timing. You may have to get a different CDI to manage the more radical timing.

Okay, I have given you my best. As I said, hold on tight to the bars. Do me a favor and don't kill yourself. You are playing with fire here. I am serious about that as well. I forgot to ask / mention, who will do the cam removal and re-install the cam? I strongly suggest the dealers service department so you have an experienced hand in the mix. Also, you will probably need to re-jet the carb. Ask the cam shop about that as well. There may well be a cam shop in Malaysia or closer than California in the USA. Check around A “very helpful” rating for this answer? Thanks!

Posted on Jul 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can any 1 help i got a dtr 125 03 model and its splutters after 7 grand in every gear it must be fuel/power valve problem


Firstly, when riding this bike do not ride past the splutter, this could be for. Number of reasons, ignition breaking down, wrong grade of spark plug ,fuel air mixture as an event of worn or damaged crankshaft seals, cdi ignition moduel, coil, ht lead arking out,does this have the original exhaust? Maybe it needs re jetting, has this bike always behaved like this or did the fault develope slowly? the list goes on

Jun 12, 2011 | 2004 Yamaha DT 125 R

1 Answer

Does my 1500 vulcan nomad require regular gas or the premium octain grade gas


regular gas will not hurt your bike but the higher grade you put in it the better it is for it, but it is not a performance motor or a race bike so you will be fine with a lower grade fuel.

Apr 18, 2011 | kawasaki VN 1500 Vulcan Classic Tourer -...

1 Answer

How to Maintain a Bike's Tire Pressure for Good Performance?


Buy a good floor pump with a gauge (see "How to Buy a Bike Pump," under Related eHows). A small, frame-mounted pump is useful only for roadside repairs.

Understand that it's normal for most tires to lose up to 10 pounds per square inch (psi) per week. This does not mean you have a slow leak.

Look on the tire's sidewall for tire pressure recommendations. Don't exceed the maximum tire pressure listed.

Inflate your mountain bike's tires to 40 psi for dirt riding. You may wish to inflate your tires to 50 to 60 psi for city riding.


Inflate your road bike's tires to 100 psi for road riding. Some road tires have much higher psi ratings. However, 100 psi will provide a good mix of performance and comfort.


Inflate your hybrid bike's tires to 60 to 70 psi for city riding.

Check your tire pressure before every ride

Dec 21, 2010 | Cycling

1 Answer

WHERE DO WEGET THE YAMAHA RX100


hi anbudharin; welcome to the forum!
yamaha RX100 bike is excellent
1) no maintenace 2) engine power and pickup awesome 3)best suited daily ride 4)especialy its sounds rocking in the city
If anyone planning to buy used Yamaha Rx100, Just go for it by closing your eyes. If you could spend few hundreds initialy you can renew ur bike as like new one which you cant get it from any other bike

Keep track of the 2T oil regularly, if you ride a bike without oil, performance of the engine may go down. I drove this bike form bangalore to hubli once in a three month and I love to ride this bike on such a long drive
if u want seconds pls gothrough this classifides http://www.clickindia.com/search.php?q=yamaha+rx100+bike+for+sale

May 22, 2010 | Yamaha RD 250 Motorcycles

1 Answer

Nsr 125 problem


It may be a safety switch in the clutch lever or bike stand switch being a bit sticky or broken wire in the wiring harness near the steering head that bends alot.

Apr 25, 2010 | 2000 Honda NSR 125

1 Answer

Poor high performance


and I was having very poor high speed performance. The bike could just barely hit 70-75 but I was loosing speed going uphill (even on slight grades). I could maintain 55-60 MPH but anything above that and the bike just didn't have any power. Probably needs a fuel system cleaning, Stu. Drive-train? Not likely, based on what you said. However, if the RPMs are rising without an increase in MPH, well... that's a different story. What won't help: High octane fuel nor octane boost. Your Honda should do fine with 87, and 93 ain't gonna clean the crud out. What may help: SeaFoam (from the auto parts store) may clean things out fairly well. I've had good success with it in situations like this, but it may take several doses to see improvement. Standard dosage is one ounce per gallon of gas. New spark plugs won't hurt but you may not notice any difference. What would be better: An all-out attack on the carbs, including disassembly, soaking in carb dip, re-build kits and a good synchronization. BTW, a decent carb-sync kit can be had for around $40. I'm glad you have a manual - lots of guys try to work on their bikes without 'em. Wacko Rolling Eyes It's like bashing my head against a wall... Oh... welcome to the forum!!!,,,

Nov 10, 2008 | 2008 Beta RR 125 Motard

Not finding what you are looking for?
2001 MZ 125 SM Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top MZ Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Jay Finke
Jay Finke

Level 3 Expert

1338 Answers

RAYMONDO1953

Level 2 Expert

545 Answers

Are you a MZ Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...