Question about 1998 kawasaki VN 1500 Vulcan Classic Tourer

1 Answer

Hesitation. I'm getting a hesitation when I first open the throttle, every gear. It doesn't happen all the time. I've got new plugs, air filter and the gas is good. I've tried SeaFoam etc...Any idea's THANX. And please don't tell me to Sync. my carbs. I only have 1 Carb.....THANX.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 221 Answers

Transfer ports could be pluged or ilde jet could use adjustment

Posted on Jul 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Abs light on 1999 mercury sable


Hesitation problems can be caused by a number of thing's on vehicle's with electronic fuel injection , not like the old days of carburetors where most likely it had a bad accelerator pump . Throttle position sensors (TPS) can get a worn spot that would act just like a bad accelerator pump . MAF sensors (mass air flow ) Can also cause Hesitation plus ruff running , bad fuel economy , a IAT sensor ,(intake air temp ) ECT - engine coolant temp. sensor can also cause this problem . Unless you want to replace all these parts i suggest you have it diagnosed by a qualified repair shop that has the electronic diagnostic tool to test it .
ABS light on , DTC- diagnostic trouble code could be set in the EBCM - electronic brake control module . could be a wheel speed sensor getting ready to fail .

Mar 21, 2017 | 1999 Mercury Sable

1 Answer

1996 mazda mx6-hesitation problem when accelerating-i have replaced spark plugs and gapped at.044-new plug wires-fuel filter checked timing-new egr valve also-egr valve helped problem on a scale of 1-10...


The rubber hose from air filter box to throttle body commonly splits along one of it's grooves and will open up on acceleration and cause a hesitation

Sep 06, 2011 | Mazda MAZDA6 Cars & Trucks

1 Answer

I got a blazer a few months ago and it has a slight miss in it when given a little gas however it seems just fine....I've paid a mechanic $440 so far on fixing up this vehicle. (idle arm,door...


GM is good for hesitation after a while. Some thing you can do, all it takes is a flat screw driver,. Get a can of brake clean. remove the mass air flow sensor, it is the one the in between the air filter and engine, big sensor. There is a tube/prong in the middle of it , spray this on both sides, This doesn't take much. Then remove the tube that is connected to the engine/ throttle body. Use a tooth brush and clean the inside of this, open the throttle plate and clean the back of it and down inside as much as you can. Start the truck, this will take a second or two. Rev it up and spray some more into the throttle body. This helps alot for hesitation on all of the GM or Chevy Engines. Let me know Randy

Aug 01, 2011 | 1995 Chevrolet Blazer

2 Answers

It been hesitating and yes i've ran out of gas a few times


It could be a lot of different things. It could need a good tune up. A fuel filter. Or it could be a little more involved like the fuel pump. You said that you have ran it out of gas a few times, believe it or not but the fuel pump gets cooled off by the gas in your gas tank. If running out of gas is a common occurrence for you the pump could have gotten too hot overheated and now is showing signs of failure. The first thing I would do is check the spark plugs and possibly replace them. That is going to be the cheapest route. If not then it could get more involved. Good luck!

May 18, 2011 | 1997 Buick LeSabre

1 Answer

Major hesitation at cold idle, car accelerates at a slow pace, hesitation also appears when in passing gear. replaced fuel filter 2 months ago


symtoms of a bad coolant sensor: poor car idle, rich mixture, retarded timing, slow idle speed, cold hesitation or stumble, poor fuel milage, check and make sure air filter is clean. and check plugs and wires if need be,

May 02, 2010 | 1992 Honda Accord

1 Answer

My 2001 galant hesitates on acceleration. changes plugs oil air filter etc.. any thoughts?


a faulty tps sensor will cause hesitation on acceleration.also a loose or broken place in air duct to throttle body will cause hesitation.also clogged fuel injectors and fuel filter.to save money have car scanned.if you have a faulty tps.the scanner will tell you.

Nov 29, 2009 | 2000 Mitsubishi Galant

1 Answer

I have hesitation on my 95\gmc \Pickup\ 5.0 Litre


you need three things for you engine to work right.Air fuel and spark. The timing could be off,the fuel filter may need to be changed,and your throttle body could need cleaning.

Jul 30, 2009 | GMC Sierra 1500 Cars & Trucks

Not finding what you are looking for?
1998 kawasaki VN 1500 Vulcan Classic Tourer Logo

Related Topics:

286 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...