New drive belt
SOURCE: Belt broken; how do I fit in a new one?
I believe the platter simply lifts straight up off the spindle. Put the new belt on the platter and reinstall it. Then, working through the access hole in the platter, put the belt around the motor drive shaft. Rotate the platter a couple of revolutions to make sure everything's seated properly and you should be back to spinnin' the hits in no time!
SOURCE: Sony Belt Drive Turntable Platen speed
Check for grease on the platter or anywhere in the mechanism. Sometimes somebody has messed around with the speed preset, there might be two. You could try adjusting them. Sometimes they are found on the underside of the turntable, covered up, or they will be on the PC board of the deck.
SOURCE: Kenwood Trio Turntable belt broken.
I have them listed as item 250423608612 on Ebay .. softwaredivision
SOURCE: model PS-LX300USB Turntable Drive Belt
Hi Norman
Normally the belt does not go through any special tensioners or anything of that nature,The belt should go directly from the spindle motor onto the inside of the platter. Hook the belt on the motor section and lay the belt open wide inside the turntable. Next, replace the platter and manouvre the belt onto the platterinside through the two large holes
180 views
Usually answered in minutes!
×