Question about 2000 Suzuki GSX 750 F (Katana)

3 Answers

Changing chain on gsx750f 2000 model / katana in usa

I have no idea how to change a chain.. I believe I will need a chain cutter, but what to I need to remove in order for me to replace the chain, do I need to grease anthing other then the spray lube for the chain?
I was thinking of finding the 'connect link' and unhook from the old chain and hook to the new one and slowly feed it through. any suggestions? I dont have a workshop manual so i dont know what to remove where the front sprocket is located [if I need to that is] apprciate all the advise I can get cheers.Godwin

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,976 Answers

ALL chains have a master link. If the wheel hasn't been moved since original installation, just remove the old chain and install the new one. It will be tighter but it should fit without any major issues.

Posted on Jul 01, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 867 Answers

You said it all, most bikes have a master link, if not you need a chain breaker, which you can also use if the new chain you purchase is to long. lift bike on center stand, loosen axle nut, then loosen chain adjustment screw nuts on both sides and turn them so the wheel/axle moves all the way forward. connect the old chain to the new chain and pull it through (while gearbox is in neutral). adjust the chain adjust screws on the axle the same amount indicated by the markers on swing arm until chain has a deflection of half inch up and down in the middle at the tightest spot, try turning the wheel a few cycles to find it. then lock axle nut then tensioner lock nuts.

Posted on Jul 01, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Suzuki Expert
  • 386 Answers

IF IT DOES NOT HAVE A SPLIT link go moneto ebay you will get a link splitter for cheapo money, when feeding new chain through attach to old one, put in neutral and pull one end of old chhain and the new one will follow, I am opening a repair shop in uk sod it, in Manchester any need a clever man to fix a bike. me shaun.

Posted on Oct 26, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 gsx750f rev counter showing double of what ot should


Hi Dick, this scenario is usually caused by a mis-wiried ignition coil, changing from a single fire coil to a dual fire or vice versa.
For more information about your question please visit the website below. Good luck and have a nice day.
Suzuki Katana GSX600F GSX750F Service Manual Cyclepedia

Sep 06, 2015 | Suzuki GSX 750 F (Katana Motorcycles

1 Answer

Will a 1999 gsx750f gear cluster fit


when investigating this make sure that the ratio of all the gears are the same for the two clusters
it is not uncommon for manufacturers to change certain ratios to get better performance between gears in different models of bikes

May 21, 2015 | 1995 Suzuki GSX 750 F (Katana)

1 Answer

How to adjust carberator floats


  1. Suzuki GSX750F Katana - Motorcycle Specs

    www.motorcyclespecs.co.za/model/suzu/suzuki_gsx750f_05.htm Suzuki GSX 750F Katana. Year. 2004-05. Engine. Four stroke, transverse four cylinder, DOHC, 4 valves per cylinder. Capacity. 748 cc / 45.6 cu.in. Bore x Stroke ...

Apr 28, 2015 | 1996 Suzuki GSX 750 F (Katana)

2 Answers

1996 suzuki 750 katana can you buy just the carb bowl gasket and the gas needle valve


Yes you can buy a needle valve assembly which consists of a needle ,o ring,and needle seat.in the UK they are about £40 each !

Apr 12, 2015 | 1996 Suzuki GSX 750 F (Katana)

1 Answer

How much oil does it take


Engine/transmission oil Type API grade SE or SF (minimum) Viscosity SAE 10W-40 Capacity With filter change 3.9 liters (4.1 US qt, 6.9 Imp pt) Oil change only 3.6 liters (3.8 US qt, 6.3 Imp pt) Engine overhaul 4.9 liters (5.2 US qt, 8.6 Imp pt)
Source: Suzuki GSX750F numbers

Sep 15, 2014 | Galfer 2005-2006 Suzuki GSX 750F Katana...

1 Answer

I have a gsx750f, a 2000 model, it seems to be getting some rust around the fuel filler section when you open the cap lid, how can I remove it (about 6 bolts I can undo) what else do i remove to safely...


I would get some naval jelly and brush it on and let it set as directed.
repeat if required, there are rust arresting products abailable that encapsulate the rust. or rust oleum if nothing else.

Dec 27, 2010 | 2000 Suzuki GSX 750 F (Katana)

1 Answer

WHAT SIZE PITCH,CHAIN/SPROCKET FOR GSX750F AND CAN I GET MORE SPEED BY CHANGING NUMBER OF TEETH


Chain size should be a 530 link. Going smaller on the rear gives more speed, but less power!!! Going bigger on the front gives more speed also.
Keep in mind that one tooth bigger on the front sprocket is equal to 3.5 teeth smaller on the rear.

Sep 29, 2009 | 1991 Suzuki GSX 750 F (Katana)

1 Answer

Spark plugs keep fouling out


TOO RICH!!!!
could be just the mixtuer is out on a couple of cylinders [ float levels ]
if revs ar changing fo no apparent reason thats the diaghrams

Jul 18, 2009 | 1996 Suzuki GSX 750 F (Katana)

2 Answers

It wont stay running in stalls out from time to time


Change the fuel filter,clean the carb jets again,and replace the air filter.This should take care of it but sometimes when they sit for awhile,you will need to clean the carbs numerous time as the gunk in the tank continues to wash down into the carbs.

May 03, 2009 | 1996 Suzuki GSX 750 F (Katana)

Not finding what you are looking for?
2000 Suzuki GSX 750 F (Katana) Logo

367 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...