Question about Harley Davidson FLSTC Heritage Softail Classic Motorcycles

2 Answers

1996 FLSTC - Power comes on very intermittently, when the start button is hit there's a loud click/snap sound and power goes off. Battery is fully charged.

Posted by on

  • sonikcycle Jun 30, 2009

    Doesn't turn over at all.

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 173 Answers

If you have alon key you can open spark plug easily.

Posted on Jun 30, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi,

My guess would be one of the teeth has been sheared off of one of the gears in the transmission, perhaps from abuse from the previous owner from speed shifting....

Thanks for contacting Fixya

Posted on Jun 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 chevy van won't crank put in a fully charged battery it started then turn it off and won't start up again why?


couple things come to mind: bad cable or starter has a dead spot. if it starts after hitting the starter with a hammer, you have a dead spot and need to replace the starter. If not, check both battery cables--the ground one that goes to the engine and the positive one that goes to the starter. Sometimes they go bad under the insulation. Could also be an intermittent ignition switch issue. A second test you can do to narrow down the possibilities is to put power directly to the starter solenoid (usually done by carefully crossing the big battery terminal on the solenoid with the small terminal where the ignition switch wire connects using a screwdriver), but make sure the tranny is in park or neutral. If the starter cranks, you know it is a problem with the ignition power not getting to the solenoid and not a bad battery cable.

Jun 12, 2015 | Cars & Trucks

1 Answer

Gateway intermittent shutdown


I installed a new alternater th battery is new

Dec 27, 2013 | Gateway MD2614u Notebook

1 Answer

1996 GMC Yukon will not start after hearing intermittent clicking noise while running


Sounds like you lost the serpentine belt, which runs the alternator. When you heard the ticking sound, did you notice if the battery light came on, Check the belt and fully charge the battery. Do not jump a dead battery. Wear safety glasses when servicing a battery, an explosion and acid hazard exist

Aug 23, 2017 | 1996 GMC Yukon

1 Answer

Bluetooth wont charge or power on. when charging the red light comes on. once disconnected from charger it wont come on


Indicator Lights:
1.Headset Status Headset Indicator Light
2.Powering on Steady blue, then intermittent flashes
(changes to standby mode)
3.Powering off Red appears and goes off
4.Standby Blue intermittent flashes
5.Charging battery Red solid light. Light indicator turns off when
battery is fully charged and headset is off.
6.Low battery Triple red flashes
7.Pairing mode Blue/red alternating flashes
8.Missed call Purple flashes. Press the call control button
to cancel flashing light.
9.Incoming call Triple blue flashes when ringing.
Power on and off:
1.Turn on the headset Press and hold the call control button until the
indicator glows blue. You will hear ascending
tones.
2.Turn off the headset Press and hold the call control button until the
indicator glows red. You will hear descending
tones. When power is off, indicator stays off.
If none of this is helpful then it may be that your battery is dead, if that is the case then you will need to replace the whole headset. The battery's are not replaceable.

Good luck from Headsets Direct!

Sep 21, 2011 | Plantronics Explorer 220 Bluetooth Headset...

1 Answer

1996 Acura 2.5TL Electrical Problem


sounds like the starter motor may be on its way out give the smaller of the cylinders a LIGHT tap with a hammer to free up the bushes, get someone to help and crank the engine over if it works find another on or get it repaired

Jun 18, 2010 | 1996 Acura TL Series

1 Answer

I have a yamaha triple 1100 and when I hit the button just a clic


You have a bad connection either at the battery terminals or the starter terminal. If the battery is new and fully charged and was not accidently drained overnight by another power source,then a thorough inspection of battery connections is needed. Not much else to cause this primary starting circuit problem,other than the starter itself.

Jun 09, 2010 | Boating

1 Answer

My sony trinitron xbr television will not come on. The power available ligt, flashes at at 7hz and off for 3 constantly. When you push the power button it sounds like its about to come on, then within one...


sounds like a high voltage arc. there are several parts that can cause this. if you want guidance i can help you but you must be careful there is aprox. 30,000 volts in that "snap" ...

Dec 28, 2009 | Sony FD Trinitron WEGA KV-32XBR400 32" TV

1 Answer

50HP66 Plasma TV wont turn on fully. I hit the power button. It goes green for like 3-5 seconds then go back to red off light. It continues this untill I unplug the TV.


did you get your tv fixed? have same problem last night...a loud click and then blank screen and just tries to turn on, can you email at res116@comcast.net

May 18, 2008 | Toshiba Televison & Video

1 Answer

No picture or sound


take you tv to tech you have damaged your microchip and component in the power supply

Dec 20, 2006 | Samsung TXN3245FP 32" TV

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4912 Answers

Mike

Level 3 Expert

4349 Answers

yadayada
yadayada

Level 3 Expert

79865 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...