Abs light stays on
SOURCE: shows ABS fault on dash and ABS light stays on
Check your abs connectors they might have pulled a wire loose
SOURCE: bmw 316 ABS light stays on
Your ABS systems use a combination of electronic and hydraulic systems to modulate the brakes individually to prevent them from locking up. Antilock systems consist of wheel speed sensors, a hydraulic control unit (HCU), and an electronic control unit (ECU). Because of how complex the system is your computer does a self-test. If the check is successful, the ANTILOCK and BRAKE lights will go out within a few seconds. If one or more of the component of the ABS system fails to pass one or both lights will remain lit, the system will shut down and set a code. The code itself does not tell exactly what component is defective - it only indicates where to look, or what parameter is out of normal range. You or a technician will have to perform further testing to pinpoint cause and the proper repair. Even if you reset the light, if the underlying problem is not addressed it will come back on.
Please let me know if this information is helpful. Positive feedback is appreciated. Thank You!
SOURCE: ABS light flashs - push switch and it stays on completley
it is caused by low battery voltage run bike for about a mile then stop turn of turn back on wait till abs lights go out then start
SOURCE: ABS and ASC warning lights stay on 2000 530d
Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car
381 views
Usually answered in minutes!
×