Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jul 12, 2014

2002 barina xc automatic choke does not work when motor is cold

Motor turns over ok when starting but does too many revs before firing, it has a new battery. how do i fix the automatic choke as i think this could be the problem.

1 Answer

Stan Ford

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

  • Holden Master 3,131 Answers
  • Posted on Oct 02, 2014
Stan Ford
Holden Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

Joined: May 16, 2011
Answers
3131
Questions
2
Helped
905618
Points
9078

I think this model has fuel injection get the cold start system checked out.

5 Related Answers

Newtown Car Care Center

  • 118 Answers
  • Posted on Sep 11, 2008

SOURCE: when starting from cold it

if the idle goes up and down constantly it will be the iac motor which is common on hondas 

Ad

Anonymous

  • 25 Answers
  • Posted on Mar 22, 2009

SOURCE: location coolant temperature sensor 4.2 liter envoy ?

COOLANT TEMP SENSOR IS MOST LIKELY BAD. NEED TO CONNECT TO THE OBD CONNECTOR WITH A COMPUTER AND SEE WHAT TEMP THE COMPUTER IS SEEING.

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Jul 18, 2009

SOURCE: 1995 Mitsubishi L300 Van 2ltr aspirated motor,

If it's carburetor & has automatic choke, then there is probably a screw at side of carb, by step cam that moves with choke . Back it of a little at a time until you get desired cold idle speed. Make sure you turn step cam to setting it would normally be when cold, and choke on, then turn screw out to lower rpm's. Look for a little rod from choke shaft, down to base or side of carb area, to step cam.

Randy

  • 369 Answers
  • Posted on Mar 26, 2010

SOURCE: 2002 ford explorer wont start even after new battery...

Before you go changing out the starter check for a burnt out fusible link going to the starter it will look like a wire but acts as a fuse and they burn in two just like a fuse. The symptoms you just describe are those of a burnt fusible link.

Anonymous

  • 16 Answers
  • Posted on Mar 29, 2010

SOURCE: mercedes vito 110cdi starter motor problems. only when the van

1.)its the alarm system cant be nuffin wrong with the starter motor i had i problem i changed the battery put a new one on and it did it so all i did was put a switch on the wire were you connect the battery very time you get in the car switch it on and strat the car in one go but evey time your job is finshed with the car switch it off but your alarm system anit gona work then
2.) but a extra battery pack the ones they use on sound systems in cars

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to check the choke is ok or not

which maker of vehicle
if an automatic choke
look at the top of the carby cold
start the motor
watch if the top butterfly opens up and engine revs drop
0helpful
1answer

Looking for the location of the crank angle sensor on a 2004 XC holden barina 1.4 motor ? , thanks

side of motor firewall side down near cv shaft that goes into gearbox if you look there you will see a 8mm bolt with the sensor going into the side of motor
0helpful
1answer

Hi, my 2002 Barina xc turns over but won't start anyone got any idears

run fault codes and look for cam/crank position sensors. Check that the cam shaft is turning ( broken timing belt). check operation of immobilbiser
0helpful
1answer

I need a diagram for the fuse box located near the battery of a holden barina xc 2001 as I need to find which fan relay that keeps coming up on the computer. I have one diagram of the one near the front of...

GMC xc barina fuse box location Questions & Answers - Fixya

www.fixya.com/tags/xc_barina_fuse_box_location/browse/gmc
Locked stereo in 1995 Holden Barina My battery went flat in my barina and now the ... Just changed the battery in a 2001 Holden Barina now there is no power just ... fuses should be in the box under the hood, there will be a diagram showing ... a 1984 gmc jimmy s15 fuse box located? the fuse box should be located near or ...

2002 Holden Barina Comments (r97719), Page 4

www.carsurvey.org > Holden > Barina > 2002 > Review
Apr 19, 2013 - 2002 Holden Barina from Australia and New Zealand - Comments ... The relay is in a box with a plastic cover on the left side (passenger) beside ... Hi, your Combo problem is the MAF sensor located near the air intake ... Hi I was hoping youfound the problem to your car, as my daughter's 2001 XC Barina is ...

[PDF]holden barina fuse box diagram - Donnie Slocum

www.donnieslocum.com/file/h/holden-barina-fuse-box-diagram.pdf
0helpful
3answers

Holden barina left hand sideblinkers not working

check the turn signal relay that usually goes before the fuse
1helpful
1answer

MY HONDA ACCORD HAS PROBLEM AT COLD START

The Part that is defective is one of 2. First is the Coolant Temp Sensor (Not knowing how much Fuel to give to the Engine) or the IAC (Idle Air Control Valve)... These are the 2 things that effect FUEL getting to the Cylinders to fire. Of course there are other things it could be (Low Fuel Pressure) caused by a air leak in the system or a few others but the first 2 is where I would have started...
3helpful
2answers

1995 Mitsubishi L300 Van 2ltr aspirated motor, Automatic choke revs extremely high on cold start, will not decelerate till engine is hot. How can I remedy this?

If it's carburetor & has automatic choke, then there is probably a screw at side of carb, by step cam that moves with choke . Back it of a little at a time until you get desired cold idle speed. Make sure you turn step cam to setting it would normally be when cold, and choke on, then turn screw out to lower rpm's. Look for a little rod from choke shaft, down to base or side of carb area, to step cam.
Not finding what you are looking for?

319 views

Ask a Question

Usually answered in minutes!

Top Holden Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Holden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...