Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

Was running fine till whent on long ride, now it dont want to start,when it dose start it will not rev up much,it will run for alittle bit then dies and will not start back up, i tried cleaning carbs and fuel lines nothing changed

Posted by on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 52 Answers

Posibly a problem with the stator

Posted on Jun 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Problem with my fzr after first ride in the morning iit wants to die wen taking off an most of the time it will then start it an it wont rev if let throttle go it will die


I'll tell you why. It is cold natured. I have a 89' Virago, and it doesn't like going anywhere till' it is warmed up. I usually just set the choke up a bit for about 5 minutes, and then hop on and go.

Apr 15, 2013 | 1988 Yamaha FZR 250

1 Answer

Having problems with my 1998 suzuki RM 125


The plug you need is an NGK R6918B-9. they aren't cheap. I would think this may be the problem. 2 strokes rely on the correct bits to keep them running smoothly. Spark plugs are more important on 2 strokes than 4 strokes due to the oil in the fuel/air mixture.

Jul 21, 2012 | Motorcycles

1 Answer

Hi, victa 550 powercut, 10 yrs plus old, problem apart from old and used is it starts runs and dies then just when you think its gonna stop it revs up again and dies and revs and dies and revs and...


Take apart the carb and give it good cleaning maybe even but a rebuild kit if available. also disconnect tank hose from carb and empty tank into clear glass jar. Sounds like there might be some water in your gas. In the glass jar you will see a clear line of liquid at the bottom that would be water, even just a little will give these similar symptoms. Good Luck....

Mar 09, 2011 | Garden

2 Answers

Samurai runs fine till tou turn on anything


need to make sure the altanatator is working right. might be shorting out while idling ive heard of it before does it do it more when u turn the ac on

Oct 30, 2009 | 1987 Suzuki Samurai

1 Answer

Yamaha 535 stalling out and losing power after running for a bit


Sounds like a fueling problem either water in the carbs or the fuel flow from the tap is insufficient. If there is a vacuum pipe it may have been dislodged or holed.
Ride Safe
Bike-Doc

Please mark this as useful (if it has been!!)

Aug 03, 2009 | 1993 Yamaha XV 535 Virago DX

1 Answer

Carb adjustment


Screw both screws right in (don't force them) Then turn each screw out 1 & half turns each OUT. This will get engine running. To fine tune- turn low speed screw out, bit by bit, while idling, till engine revs change, then turn screw in till revs change, the correct setting will be somewhere between the 2 adjustments you just made. Do the same thing to the high speed screw, but with full revs. Good Luck. Stevo..

Jan 16, 2009 | Garden

3 Answers

Ryobi 31cc lawn trimmer carb adjustment


As with all 2 strokes if you have compression and a reasonable spark, you only need fresh fuel with correct oil ratio) and they must go !(as long as you haven't fiddled first and all gaskets are sealing) I start mine by(1) pumping the primer till it is firm,(2) full choke,(3) pull till it kicks ONCE,(4) half choke, pull till it runs,allow to warm up and(5) switch to run (you may need to apply a bit of throttle while pulling as in (4)(or give it a few more pumps if it dies) If all is ok, check that when properly warmed up there is a smooth transition from idle to full revs, if it hesitates it may need the LOW SPEED mixture leaning (clockwise) SLIGHTLY.If it dies the LOW SPEED mixture may need richening(anti-clockwise)(adjust 1/8 turn at a time) Make sure that motor is just peaking at full revs and is on the RICH side of peaking (HIGH SPEED mixture)(this will avoid seizing it Adjust both till it revs cleanly and is JUST rich at full, and idleing nicely and it should start without too much trouble.(If you have fiddled and are lost,-about 2 1/2 turns out from closed on both needles should get you started)

Nov 23, 2008 | Garden

3 Answers

Lawn mower dies


Find the fuel air mixture screw and while the mower is running turn so mower almost stops then turn them back till the moter is running smoother.Give it some throtle to see & hear how it is running

Nov 02, 2008 | Craftsman 17.5 hp 42 in. Deck Lawn Tractor...

1 Answer

Engine over revs at initial start up without touch accelerator. Shut down and restart, sometimes problems goes away.


it all depends on what yr the ford is b/c my grandmas car dose it a lot when you go to shut the car off make sure it is in park and it is in a idle then when you start it it should be fine if not go under the hood and see if it accelator can be lossened a littel bit if so it will save you on gas and the idle wont be as high. if that dose not work then dont worrie about it it wont harm the car any and dont pump the gas pedall while the car is not running

Jul 09, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...