Question about 2005 Honda CR 250 R

1 Answer

I have a 2005 cr250 and its got no spark

I have a 2005 cr250 and its got a new plug and coil pack and it still got no spark wot could be wrong

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 207 Answers

The cdi is the best bet but get a test light and have someone kick the bike over while you see if the stater has power comming out of it the stater is on the left crank case cover you will see the wires comming out of the cover but the cdis go out a lot more often than the stater with the bike being a 05 its a 90% shot

Posted on Jun 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu 2ltr bakkie nmbr 2 and 3 no spark?


post 3, adds, no spark , 2/3 (and still no year, no country stated)
bad coil pack?
wired wrong, this pack.
no photo of the engine, nor real name of it, Petrol.
btw, we dont have "BAKKIE" here. not a single one.
nor KB trucks, either.
what spark system this car has, im clueless.
4 coils or 1 pack.? if one pack , replace all spark wires
if one pack system , if either 2/3 wire opens, both cylinders go dead. try new spark wires. high voltage,

or you measured spark wrong, on 1 pack car.
it takes 2 spark plugs do do that. 2 good plugs and 2 good wires,
#2 and #3, due to the fact they are wired, in SERIES.
see its called wasted spark system, with 1 coil pack and no distributor..
the testing is unique. on this, setup.
try new spark plugs, gapped correctly
and 4 new HV wires,
I bet its go. if not the coil pack is toasted.

Dec 05, 2016 | Isuzu Cars & Trucks

1 Answer

I changed spark plugs on my 01 jeep grand cherokee it was running but turned off on me now it wont start anymore.


which engine?
2001 WJ , jeep.
wrong spark plugs!
gapped wrong!
wrong wire order?
do tell engine you have there.
do tell park plug brand and numbers.
do tell if engine has coil packs, how many, and how you wired them back..
now answering for USA cars, (not exports. or those jeeps made in Europe. )

the 4.0L engine with the 3 coil rack pack? with 6 spark wire sets?
the 4.7liter has 6 coil packs coil over plug COPS.
that can not be wired wrong but could be unplugged in primary side.

my guess, wrong parts, wrong gap
or not reconnected right.
if spark is lost, scan the PCM cranking, look for DTCs/

Dec 24, 2015 | Jeep Cars & Trucks

1 Answer

Changed spark plugs ht leads and coil and still the car is missing when i drive it wot am i missing


With the miss you have it could be a few things.
did you change all the coil packs?
did you refit the heat shields to the new spark plug needs as these can cause a miss .
it could be the electronic module under the coil pack.
it could be a faulty injector or fuel problem..

Aug 31, 2013 | 1998 Holden VT Commodore

1 Answer

Have a Ford Escape 2005... Coil packs C and D were bad ...now check engine light on and seems like it is trying to backfire through my intake????


Hello, Were the coils changed? Perhaps the wrong wire was put on the wrong plug. You need to somehow scan the engine to find the defect and to clear the computer. It sounds like the engine is trying to fire when the piston is in the wrong place.

If you did not have any work done yet, then the spark from the bad coil is going somewhere else and firing a cylinder out of time. This can happen when the sparks jump. You can temporarily use cardboard as an insulator around a plug to keep the spark from jumping. The cardboard will burn from the heat, but in testing it will identify an open wire.

Jul 03, 2011 | 2005 Ford Escape

1 Answer

1985 Honda CR250 no spark


Hi, Melisamoore2 and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting/leaking, spark plug cable connections loose check for spark leakage in the dark.
6. Faulty ignition coil or electronic control module.
7. Faulty CKP, CMP, or BAS sensor.
8. Faulty ignition switch.
9. Tilt sensor needs a reset.
10. Security alarm failing to disarm needs reset
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
1985 CR250R is getting no spark What could it be
How to fix No Spark Problem on Motorcycles and Dirt Bikes
CR250 2002 2003 pdf
http://www.partsfish.com/page/oem-parts-for-honda
Honda CR250R Owner Manual Competition Handbook

Oct 03, 2010 | Honda CR 250 R Motorcycles

1 Answer

How do you get to the spark plugs 2005 hyundia santa fe


There's a plastic cover on the valve cover, remove small bolt's holding cover, under cover will be two coil pack, and a total of 4 spark plug wire's, remove small bolts to coil pack, will have two bolts to each coil pack, disconnect elec. harness, remove coil pack, spark plugs will be in there.

Sep 20, 2010 | 2005 Hyundai Santa Fe

1 Answer

2005 Cavalier misfiring on 2 cylinders, dumping fuel


Spark plugs get there voltage from the ignition coil packs, more then likely you have a bad coil pack or coil pack boot, pull one coil pack or spark plug wire or boot at a time, if you see a drop in rpm, that one is good, if no drop bad coil pack.

Jul 19, 2010 | Chevrolet Cavalier Cars & Trucks

1 Answer

How do i put in spark plugs in my 2005 dodge ram 1500


I'm assuming this is a 5.7 hemi. Remove the 8 coil packs that are bolted to the top of the valve cover. You can do 1 at a time. Each coil pack has two spark plugs under it . use a 5/8 spark plug socket and extention. If its a 4.7 the coil packs are held on by one 10mm nut. These packs are just inside the valve cover on both sides of the engine. There will be only one 5/8 plug for each pack

Jun 25, 2010 | 2005 Dodge Ram 1500

3 Answers

Ignition module where do I find it.


The ignition coils are mounted on it. Just follow the spark plug wires.

Nov 18, 2009 | 2005 Chevrolet Impala

Not finding what you are looking for?
2005 Honda CR 250 R Logo

Related Topics:

482 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...