Question about Suzuki GSX-R 600 Motorcycles

1 Answer

Fuel stops at injectors. - GSX-R 600 Suzuki Motorcycles

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 408 Answers

Take out the injectors and have them cleaned and tested

Posted on Jun 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I took de oil filter out i connected direct tube i start de it didnt start


Check de-compression lever. Motor will not start if de-compression lever is operated. The lever stops the valves from closing. If lever is operated then there will be no compression when motor is pulled over with starter cord or electric starter operated.



Check fuel cut off at injector pump is not operated. This is how motor is normally stopped.



There must be no air in the fuel line, fuel filter, injector jump or injector. Undo the fuel line at the injector and pull starter or operate electric starter. Fuel should spit out. If not, crank some more until fuel comes through.

if there is fuel in the tank, filter not blocked and injector pump working then if not fuel at injector then maybe injector pump faulty.



If fuel at injector line then remove injector, crank motor and look for spray of fuel.



If if you have checked for spray of fuel and motor compression then motor should start.

Mar 15, 2015 | Kipor Kde 5000ta Diesel Portable Generator

1 Answer

Why my 1998 gmc 15oo 4.2 v6 truck after warms up injectors stop pumping fuel


The pick up in the distributor is what tells the ECU to fire the injectors, would be a likely culprit.

Aug 05, 2014 | 1992 GMC Sierra K1500

1 Answer

Fuel injection troubleshooting


run fault codes to check for problems associated with the injector electrics. Check for cam/ crank position sensor as they can stop injector operation. If you have used some sort of fuel / injector cleaner then that may have blocked up the injectors with gunk needing the injector tips to be cleaned out.

Feb 01, 2014 | Cars & Trucks

1 Answer

Car hesitates and backfires when warmed up from a dead stop


Do a injector leak down test to rule out leaky injectors.

Leaky injector will drip excess fuel into the intake on dead stop.

Back fire will damage intake manifold gasket and waste fuel.

Jan 16, 2014 | 2003 Subaru Outback

1 Answer

Fuel injectors 406 peugeot car wont start


First some questions. How exactly does it 'stop'? Is it petrol or diesel? Any warning lights or messages on the dash board? When was it last serviced? It sounds like it might be a fuel supply problem. That means it could be fuel pump, fuel filter or even a fuel injector problem!

Dec 17, 2017 | Peugeot 406 Cars & Trucks

1 Answer

I have a 1997 dodge grand caravan 3.8l v6 with about 146k. I stopped at a gas station and put gas in it (was at 1/2 tank) Went to start it and it started hard. Cranked for about 4 seconds before turning...


Have you ever put in the gasoline tank any fuel injector cleaner yet because your injectors which injects the fuel of gasoline, if the injectors are not injecting enough fuel into the piston chambers that the fuel injectors needs to be clean to allow enough fuel to come in so go buy injector cleaner at autozone and put the whole thing into the gasoline tank and then drive. Your fuel injectors are clogged or going serious bad on you so you might have to replace them as well but first try to put fuel injector cleaner and see.

Jun 09, 2011 | 1997 Dodge Grand Caravan

1 Answer

Have fuel to throttle body. Pump is working good. No fuel to injector. Engine will run when fuel is poured into tb.


if pump is good and no fuel to the injector, means the injector is stopped up. change injector and o-ring.

Dec 13, 2010 | 1990 Subaru Loyale

1 Answer

Heats up to normal temp injectors stop working...


Try higher octane fuel full tank with fuel cleaner/octane booster and give the car a long run with a blast.

Oct 21, 2009 | 2000 Toyota Celica

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4888 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...