Question about 2000 Yamaha YZF Thunder ace 1000 R

1 Answer

DIES AT TOP END

MY 400 KODIAK RUNS GOOD UNTIL YOU GET TO TOP END AND THEN IT ACTS LIKE IT IS LEAKING WAY OUT TO THE POINT THAT IT ALMOST DIES. HAVE CLEANED THE CARB AND REPLACED THE SPARK PLUG

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 52 Answers

Make sure your air filter and airbox are clean. if they're good then check that your choke is working properly.

Posted on Jun 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Yamaha Kodiak 400 4+4 best way to set motor timing and valves


check youtube for generic valve adjusting procedures, the kodiak is like most of them.

Mar 23, 2017 | Yamaha 2004 Kodiak 400 Auto 4x4

1 Answer

I have a 1999 yamaha kodiak 400 I recently rebuild the top end. It was running great parked it went back to it it wouldn't start and it acted like it didn't have any compression I took the cap off that...


no
it has to be removed there is a flexi tool that has a magnet on the end available from most auto parts shops or good tools stores
try that but it not successful then it is a pull down job

May 09, 2017 | ATVs

1 Answer

What is the cause for my kodiak 400 shift lever not to move into reverse or park


Check to see if one of the shifter rods behind the side pannel are bent.this usually happens due to lack of lube end people try to force it into gear.

Sep 01, 2014 | Yamaha 2004 Kodiak 400 Auto 4x4

1 Answer

Harley sportster won't accelerate after warm... Idles fine top end is fine


Hi Anonymous, if you have a carburator the usual suspects are:
1. Damaged or restricted fuel tank venting system (gas cap).
2. Inlet system air leak.
3. Vacuum piston malfunction.
4. Accelerator pump leaking or no output.
5. Plugged bowl vent.
6. Fuel level (float chamber) too low.
7. Restriccted fuel supply passages.
8. Plugged jets or passages.
9. Worn or damaged needle or needle jet.
10. Enrichner valve not seated or leaking.
Good luck

Jun 25, 2012 | 2005 Harley Davidson XL 883 Sportster

1 Answer

Our ozone 3 helicopter runs a few seconds and shuts down even after charging. The battery measured 8.4 volts to start. It's down to 7.1 now and acts the same each time. I'm used to nicads and their...


Hi,

It sounds like you have a bad battery.

Lipo's only like being used down to about 80% of their charge and if they are used past that it can cause problems with the life of the battery.

I would suggest you acquire other batteries from your local hobby supplier or through ebay.

Here is the item number of a couple on ebay that end in just over 2 hours going for $11.18 US

Item number: 150523469526

See how you go with that and if it doesn't fix the problem please come back to me.

Cheers,

Dave

Nov 25, 2010 | Venom Kodiak RTF 3Channel RC Helicopter

2 Answers

It acts like it is flooded, starts with choke off and throttle depressed. runs until carb runs out of gas then dies


Yes, Your carburetor sounds like it needs cleaned. Or you may possibly need to purchase a carb. kit for your trimmer if the cleaning doesn't do any good. When cleaning the carb. use a Den Tek Brush, (teeth cleaning brush), to clean the small ports. Also, check the small screen in carb. Can get clogged easily.

Jim

May 28, 2009 | Garden

Not finding what you are looking for?
2000 Yamaha YZF Thunder ace 1000 R Logo

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...