Question about 2000 Harley Davidson FLSTC Heritage Softail Classic

1 Answer

I have a sporty that im changing out the handle bars is there anything special i need to know before starting this project?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 216 Answers

If there is a big height difference, u could need new cables... in any should adjust throttle and clutch after

Posted on Jun 27, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have an Admiral washing problem is, is that it wont start...period. I have tried changing the water temperature to see if that effects it, with the door open and closed but it just wont...


What you need to do to solve the problem of your whirlpools is to trubleshoot it to resolve the problem your self.
Carefully apply the below instruction to solve the washer problem.

If your bathtub faucet leaks or performs poorly, there areways to troubleshoot the problem. A few common parts are most likely to wearout, so checking these reveals exactly what's wrong with the appliance. Thisrequires no specialized skill, and anyone who knows how to use a wrench willfind this project takes less than an hour. If you have no experience, giveyourself extra time.
1 Turn off the water to the faucet. Take offthe cap on top of the handle and remove the screw under the faucet cap with anAllen wrench. Take the handle off the faucet, pulling it away from the showerwall.
2 Remove the trim sleeve (also called a dome cap or bonnet). Simply turn itcounterclockwise and pull it off the faucet head.
3 Tighten the cartridge nut under the trim sleeve, replace the trim sleeve andhandle, and turn on the water. Test the faucet. Watch to see if the leak orproblem goes away. If not, remove the handle and trim sleeve.
4 Remove the retaining nut entirely. Turn it counterclockwise and pull it offthe faucet. Slide the cartridge out of the faucet and inspect the valve seals.If they're worn, replace the cartridge and reattach the retaining nut. Tightenwith a pliers or wrench.
5 Replace the trim sleeve and handle and turn on the water to test the faucet.
tools needed to carry out the work.

Thanks for uing fixya.

Jul 31, 2011 | Home

1 Answer

What size nut would be inside the fender. The chrome strip on rear fender is held on by 3 nuts. What size? Any special tool I need?

I don't know about your 04 Sporty but the earlier models used a 5/16 X 18 nut on the backside. No special tools necessary if you remove the rear wheel.

Good Luck

Jun 05, 2011 | 2004 Harley Davidson XL 1200 C Sportster...

1 Answer

I have a 2007 sporty custom. I need new tires. 21" front and 16" rear. I think I will go with Metzeler me 880. I see on bikebandit they have a 90/90-21 radial . Stock size is mh90-21. Would...

I have Metzeler ME 880's on my 94 FXDWG and they have their good points and their bad points. They seem to handle well but they don't break very well. Several times, I've locked up the back wheel with the brake and I didn't even know it until the rear end started to come around on me. They make no noise or anything, The rear wheel just locks up and slides. I will not buy another set. This is my opinion of them.


Feb 21, 2011 | Harley Davidson XL 1200 C Sportster Custom...

1 Answer

Im trying to change my oxygen sensor bank sensor one and need to know where it located and if there is anything special i need to know about changing it.

What size engine is in this Grand Cherokee? You should be able to get a 13/16 wrench on the hex and remove it. If clearance is an issue, then an O2 sensor socket that is available at most auto stores will be required. I'll need an engine size for an exact location of this O2.

Dec 26, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Got a sticky throttle on a honda CBR 250 rr how can i fix it

start at the handlebar end. loosen the 2 screws and slide off the throttle from the handle bar, wipe down the handle bar, and put a thin film of grease on it, then slide it back on, being sure not to slide it on all the way, about 1mm back, to prevent the handlegrip rubbing on the end of the bar. Next you need to lubricate the cable, this is best done from the top handlebar end, you need to take apart the cable housing, so you can spray some thin lubricant down the cable, such as WD-40, or you can even buy special cable lube. This will fix your problem im sure.

May 13, 2010 | 2002 Honda CR 250 R

1 Answer

My 2001 Pt Cruiser Timing Belt Pulley needs a special tool???????

im guessing a pulley press, or is it the tensoner pulley, usually a rachet head will fit in there, or even a pry bar, if one of the pulleys r bad, what ever you do to get it off, then use a block of wood an a hammer to put new one on,

Jan 04, 2010 | 2001 Chrysler PT Cruiser

2 Answers

I need 2 modify my bajaj discover to some sporty looks wht can i do???

Removing some of the parts from yor bike ll give you sporty lok. 1. Replace the chain guard with semi covered one 2. remove the saree guard 3. remove the original handlebar and install 3 peice handle bars. 4. increase the size of rear suspension. (this can be done by increasing the size of the metal holder in bottom end of the suspension).
Rate this!!

Jul 28, 2009 | Bajaj Discover Motorcycles

1 Answer

Hitachi volume bar always on, remote doesn't work

you can start by opening the front panel and check if the control board (with channel ,volume ) is correctly fixed or need to be solded.
the service manual is here in 6 parts and for free...:

Dec 21, 2008 | Hitachi FDX Series 43FDX10B 43" Rear...

1 Answer

Dead Sporty

If the battery has a charge and the connections are all good, you have to have some juice goin through your system and should at the very least get a headlight, IF the bike knows its on. I'd check the starter switch on the handle bar.....did u kill it
accidently...its happened before.....maybe a leads popped off the key switch.
if that all fails
Sometimes battery connections look good, but arent. Try torquing them a little tighter.....good luck

Aug 18, 2008 | Harley Davidson Harley-Davidson Motorcycle...

3 Answers

Viewing HDTV on a Sony 53" KP-53HS30

This TV is a projector - not a plasma. I can't see how you would get "burn in" on this set. It should handle an HD picture fine.

Jan 06, 2008 | Sony KP-53HS30 53" Rear Projection...

Not finding what you are looking for?
2000 Harley Davidson FLSTC Heritage Softail Classic Logo

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4982 Answers


Level 3 Expert

4350 Answers


Level 3 Expert

80339 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides