Question about 1986 Honda VT 1100 C

1 Answer

The spark just shuts off i hooked up a park tester while it was idieling it was running fine and it died like you hit the kill switch

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 65 Answers

I can help you but tell me when does this happen all the time? when you put it in gear? or just randomly?

Posted on Jun 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Polaris 570 started this morning fine .now it turns over but wont start .gas is full ,battery is full charge .


when you moved make sure you did not hit the kill switch that will not allow a spark .. the other thing you can try is to see if there is a spark. you can pick up a spark tester at any auto store

Feb 28, 2015 | Polaris 2014 Sportsman 570 EFI

1 Answer

Running great but shut down mid ride. Acted Like the kill switch was hit. Checked the switch it was fine. Started right back up. Ran for another minute then shut down again. Plugs have spark, fuel...


My guess is that this is not a car or truck, but rather a 4 wheeler. It may have a low oil shutoff, or bad coil that fails as it gets hot, but hen cools a bit and seems fine. Check for spark immediately as it fails.

Feb 10, 2015 | Cars & Trucks

1 Answer

Why won't my Stihl FC 55 edger run?


First remove the module and clean the mounting areas to be sure the module has a good ground. Leave the ground wire off the module and run the unit. If it runs fine then you will have to kill the motor by pulling the spark plug or choking it down. If it runs fine reattach the ground wire and run again. If ran good without wire but not with then the switch is bad. If wont run good either way then likely a module.

Aug 05, 2014 | Stihl Fc-mm Edger Kit Sleeve Mm55 55 Yard...

1 Answer

Husqvarna 128Ld wont run after 30 seconds


put the correct spark plug in it and no a CJ8 isnt the right plug !!!

Dec 21, 2013 | Husqvarna 128LD 28cc 2-Stroke Gas-Powered...

2 Answers

Craftsman ZTS 7500 dies when engage blades or when engage transmission


check the "kill switch" they are usually located in the seating area. it senses for pressure or seat angle and will kill the mower if nobody is sitting on the mower. Good Luck

Apr 17, 2012 | Craftsman Garden

1 Answer

I have no spark,it was running fine an just died.any ideas? yamaha TTR 250.


Ok I'm going to start with the standard follow the wires and check all connections routine as they can vibrate lose. Then the curve ball. Check your kickstand kill switch with a continuity tester. Even though you may see it move the electrical connection may not be completing and opening. Finally if it all checks out it may be your coil or worse your ignition module.

May 02, 2010 | 2002 Yamaha TT-R 250

1 Answer

Replaced stop switch and it still won't shut off!


While attending college, I worked at a tool rental center and learned many tips and tricks from the mechanics. The problem that we heard the most from customers was that the machine would not start. Your your machine at least starts and runs fine, however will not shut down with the factory kill switch. Many times when replacing the mag. (spark coil) the kill wire would rub against the flywheel and break or over time the conductor wire will break inside the insulation. If you kill switch only has one wire, then all the kill switch does is short the mag to ground. Simple test is to remove spark plug, re-connect wire to plug, touch plug to engine and pull rope to observe spark, then short the tab on the magnito to ground, should be no spark. If you still have spark, coil is defective however good enough to run engine. Kill with choke or pull wire. If no spark with test, make new wire from tab of coil to kill switch or any switch that will short tab to ground. Good Luck

Jan 03, 2009 | Briggs Garden

1 Answer

Chrysler LeBaron 1995


Some of those cars had a problem with the coils. If you can get a hold of a spark tester, next time your car dies install the tester and see if you are getting spark.

Aug 14, 2008 | 1995 Chrysler LeBaron

Not finding what you are looking for?
1986 Honda VT 1100 C Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...