Question about 2003 Honda Silverwing 600

1 Answer

From the Back wheel of my 2003 Silverwing I hear like a gurgle gringing sound when I turn the tire. Any ideas what it is?

Posted by on

  • Gino Cussen
    Gino Cussen May 11, 2010

    Sounds like the wheel bearings are damaged?

  • tombones May 11, 2010

    It is probably water collected inside the tire.


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 311 Answers

I dont know how water gets inside a tyre,but however,if it is a disc brake model,the brake pads are prbably worn down to the steel and need replacing,or as previously statedby another person possible wheel bearing failure,or if it is a shaft drive unit(ie has a diff)then a faulty bearing in the diff

Posted on Jul 03, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1988 Chevy suburban Starter some times makes a loud grinding sound when trying to start the truck

The brushes on the starter are worn where you hear the gringing. The grinding comes from the worn areas trying to turn over the fly wheel. Or the fly wheel teeth are doing the opposite to the starter. Hope this helps

Jul 11, 2012 | Cars & Trucks

1 Answer

Metal on metal sounding clicking noise while the wheels are turning but only on the frot driver and passenger wheels. What is going on? It started out only on the passenger side and then after the tire...

Is the noise a screeching high pitch or a growling low pitch?
It sounds to me that the CV joints might be bad and you need brakes.
high pitch would be the brake warning tabs
the low pitch would be the brake pads are gone and you are on the rotors gringing away metal

May 21, 2010 | 2000 Nissan Altima

1 Answer

I have a 2003 Chrysler 300m. When its cold in the morning it sounds like I have a flat tire front left. Tire pressure is ok and sound is more pronounced when turning. Sound goes away after it warms up. Is...

Check the tire on the front of the car for a broken belt in tire. Look on the back side for a blug,swollen area on side wall of tire. Raise the front of car and block the rear wheels, spin the tire by hand and look on both sides as tire is rotating for anything unusal. Hope this will help you.

May 18, 2010 | Cars & Trucks

3 Answers

M,y 2003 rav4 4wd steering wheel vibrates at high speed

the vibration can be your tires, it may need balance, or the tire is out of round. I had seen the tires wear unevenly can cause this. what I mean is because this 4 wheel all the time design, if any of the tire is worn more than the rest can also do that.
the noise is a different thing, it can be a ball joint or tie rod end

Apr 22, 2010 | 2003 Toyota RAV4

3 Answers

Sounds like a clunking noise, like the sound you hear when you have a flat tire, Tire isnt flat. turning right on the wheel lessons the sound but stays the same turning left. noise seems to be getting...

its a wheel bearing. .will need to be inspected to determine the correct one. Also tires could also do this if the steel seperated internally. Rotate the suspected tire to see if it follows the tire.

Apr 03, 2010 | 1990 Toyota Pickup

3 Answers

When I turn there is a grating sound, both left and right turns--doesn't happen at low low speeds or on very easy turns. 2003 honda civic

It sounds like the CV joints need some attention. These are covered with rubber boots and if the boots crack they let in water and/or dirt which cause the joints to make a popping or grinding sound. Turn the wheels left or right and look under the car towards the inside of the wheels. The boots are right next to the back of the wheels. Look for cracks in the rubber. If you can, push on the boots and check for small cracks. If they are cracked, have them looked at immediately. The longer they go like that the more damage will be caused. Thanks for using fixya.

Nov 19, 2009 | 2003 Honda Civic

3 Answers

Sand gring noise progressing

do you own jack stands ???
why not jack up the drive wheels and listen for noises ?

jack each wheel up independantly and run the car for a couple of minutes this will aallow you to clear some different noises off the list
push down on the bumber and support the axcell with a jack stand more noises gone from equasion

jack the drive wheels up 1 at a time start car put in gear and run to 20 miles or 30 km chalk the other wheels and do it where you have some space incase chit happens that shouldn't
this will allow you to track the noise to it's location

Jul 29, 2009 | 2003 Pontiac Aztek

1 Answer

Wheel rub at high speeds.

It sounds like a bad bearing on the right side hub. you can check this by raising the front of the car till the tires are off the grond. Grab the tire and try to wiggle it up and down and front to back if there is any play replace the bearing. check both sides

Jun 22, 2009 | 2003 Honda Civic

1 Answer

Steering wheel vibration and whine noise from rear of car

Yes, and it probably is your wheel bearing. Hearing a sound like a chain dragging is classic. You may also hear a clicking noise or chain dragging noise when turning to the left or right.

Look under the car and see if the rubber boots that surround the axle near the tires are cracked and leaking grease. If so, it is almost a certainty that the bearings are bad as you have lost grease and thus lubrication to the bearings.

Good luck,

May 28, 2009 | 2003 Nissan Altima

Not finding what you are looking for?
2003 Honda Silverwing 600 Logo

Related Topics:

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers


Level 3 Expert

75744 Answers


Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides