SOURCE: Need to set floats on an xj 700
with the float bowl off and holding the carb level, adjust the float where it is level and the jet is up enough to seal. float should be set then.
SOURCE: WHERE CAN I GET THE WATER PUMP SEALS FOR A YAMAHA MAXIM XJ 700 X
Try www.bikebandit.com/
Or go to yamaha for the OEM parts.
Testimonial: "im on it...! t y"
SOURCE: How do you determine the required oil level of the drive shaft?
there is a sight glass about the size of a nickle directly below the filler plug ,oil level should be midway or close to the top,you should see the oil level in the glass window,if not you'll have to remove the cover and clean or replace the sight glass window....
SOURCE: oil capacity?
Should be 3.5 Liters / quarts with the filter change. Put in 3 liters then top up as needed to get the level to the top of the viewing window.
To check your oil, bike should be level, on it's center stand, engine should NOT be running!
Any oil viscosity between 10w30 and 20w50 will work just fine. Smaller numbers if the weather's cooler and/or you only do short rides. Bigger numbers for hot weather and longer rides.
SOURCE: how to set carburetor on
Not sure i understand what you mean by set, if you have more than one carb and you want to set them together, or synch them. you need a special vacuum guages hooked to each carb, and then you synch them to the carb on the number 1. cyclinder.
If your talking about adjusting the idle, You warm up the bike to operating temp, and set the idle screw to where the bike idles at aprx 1000-1300 RPM.
If your talking about setting the A/F ratio. Find the air or fuel screw, and with the bike started, turn it all the way in untill the bike just stalls, and unscrew it about 2 turns.
All depends on what you mean by set.
629 views
Usually answered in minutes!
×